This paper presents the results of a detailed study of the structure of nanowhiskers (NWs) of copper oxide formed in the process of thermal oxidation. It is shown that NWs have a bi- or poly-crystalline structure with a growth direction [110]. It is noted that the formation of NWs is facilitated by the cooperation of internal stresses with the defective structure of the underlying coating, and they grow owing to surface diffusion of copper cations from the depth of the coating to the top of the whisker. It is established that NWs have a good sorption and photocatalytic ability that will allow their use in the chemical industry, including the areas of catalysis and photocatalysis.
1 November 2023 in ECS Journal of Solid State Science and Technology
The properties of orthorhombic κ-Ga2O3 films grown by Epitaxial Lateral Overgrowth (ELOG) were studied by Scanning Transmission Electron Microscopy (STEM), X-ray diffraction, capacitance-voltage profiling, Microcathodoluminescence (MCL) spectroscopy and imaging. ELOG mask was formed by deposition of SiO2 stripes on TiO2 buffer prepared on basal plane sapphire, with the stripes going along the [11 0] direction of sapphire. κ-Ga2O3 ELOG growth was performed using Halide Vapor Phase Epitaxy (HVPE), with ELOG wing of the structure formed by lateral overgrowth over the 20 μm-wide SiO2 stripes, while growth in between the stripes proceeded initially by vertical growth in the 5-μm-wide windows. TEM analysis showed that the material in the windows comprised 120o rotational nanodomains typical of κ-Ga2O3, while, in the wing regions, the material was single-domain monocrystalline. The films were conducting, with the net donor density close to 1013 cm−3. The data suggested the material in the windows have much higher resistance than in the wings. MCL spectra and imaging revealed much higher density of nonradiative recombination centers in the windows than in the wings.
The defect structure of α-phase gallium oxide thin films was investigated using transmission electron microscopy (TEM). Epitaxial Ga2O3 films were grown via halide vapor-phase epitaxy on c-plane sapphire substrates. TEM analysis revealed a high density of extended planar defects within the films, primarily located along prismatic planes of {112¯0} type. Displacement vectors were determined using the invisibility criterion for stacking faults. The study encompassed both planar and cross-sectional views of the films. It is hypothesized that these defects form due to the motion of edge partial dislocations with the 13⟨11¯00⟩ Burgers vector. Various mechanisms of their formation have been explored.
To exploit unique properties of thin films of group III-nitride semiconductors, the production of native substrates is to be developed. The best choice would be AlN; however, presently available templates on sapphire or SiC substrates are defective. The quality of AlN could be improved by eliminating the substrate during the layer growth. In this paper, we demonstrate freestanding AlN layers fabricated by an SiC substrate evaporation method. Such layers were used to investigate dislocation structures near the former AlN–SiC interface. Specimens were characterized by synchrotron radiation imaging, triple-axis diffractometry and transmission electron microscopy (TEM). We found that the evaporation process under non-optimal conditions affected the dislocation structure. When the growth had been optimized, AlN layers showed a uniform distribution of dislocations. The dislocations tended to constitute low-angle subgrain boundaries, which produced out-of-plane and in-plane tilt angles of about 2–3 arc-min. Similar broadening was observed in both symmetric and asymmetric rocking curves, which proved the presence of edge, screws as well as mixed dislocation content. TEM revealed arrays of edge threading dislocations, but their predominance over the other threading dislocations was not supported by present study. To explain the experimental observations, a theoretical model of the dislocation structure formation is proposed.
X-ray diffraction and transmission electron microscopy techniques have been used to study the dynamics of variation of the structural characteristics and deformation state in SiC, AlN, and GaN...
17 August 2024 in Materials Science in Semiconductor Processing