Heat accumulation and self-heating have become key issues in microelectronics owing to the ever-decreasing size of components and the move toward three-dimensional structures. A significant challenge for solving these issues is thermally isolating materials, such as silicon dioxide (SiO2), which are commonly used in microelectronics. The silicon-on-insulator (SOI) structure is a great demonstrator of the limitations of SiO2 as the low thermal conductivity insulator prevents heat dissipation through the bottom of a device built on a SOI wafer. Replacing SiO2 with a more thermally conductive material could yield immediate results for improved heat dissipation of SOI structures. However, the introduction of alternate materials creates unknown interfaces, which can have a large impact on the overall thermal conductivity of the structure. In this work, we studied a direct bonded AlN-to-SOI wafer (AlN-SOI) by measuring the thermal conductivity of AlN and the thermal boundary conductance (TBC) of silicon (Si)/AlN and Si/SiO2/aluminum-oxygen-nitrogen (AlON)/AlN interfaces, the latter of which were formed during plasma-activated bonding. The results show that the AlN-SOI possesses superior thermal properties to those of a traditional SOI wafer, with the thermal conductivity of AlN measured at roughly 40 W m-1 K-1 and the TBC of both interfaces at roughly 100 MW m-2 K-1. These results show that AlN-SOI is a very promising structure for improving heat dissipation in future microelectronics.
The measurement of in-plane motion in microelectromechanical systems (MEMS) is a challenge for existing measurement techniques due to the small size of the moving devices and the low amplitude of motion. This paper studied the possibility of using images obtained using a scanning electron microscope (SEM) together with existing motion detection algorithms to characterize the motion of MEMS. SEM imaging has previously been used to detect motion in MEMS device. However, the differences in how SEM imaging and optical imaging capture motion, together with possible interference caused by electrical actuation, create doubts about how accurately motion could be detected in a SEM. In this work, it is shown that existing motion detection algorithms can be used to detect movement with an amplitude of 69 nm. In addition, the properties of SEM images, such as bright edges, complement these algorithms. Electrical actuation was found to cause error in the measurement, however, the error was limited to regions that were electrically connected to the actuating probes and minimal error could be detected in regions that were electrically insulated from the probes. These results show that an SEM is a powerful tool for characterizing low amplitude motion and electrical contacts in MEMS and allow for the detection of motion under 100 nm in amplitude.