Oxidative stress, defined as a misbalance between the production of reactive oxygen species and the antioxidant defenses of the cell, appears as a critical factor either in the onset or in the etiology of many pathological conditions. Several methods of detection exist. However, they usually rely on ex vivo evaluation or reports on the status of living tissues only up to a few millimeters in depth, while a whole-body, real-time, non-invasive monitoring technique is required for early diagnosis or as an aid to therapy (to monitor the action of a drug). Methods based on electron paramagnetic resonance (EPR), in association with molecular probes based on aminoxyl radicals (nitroxides) or hydroxylamines especially, have emerged as very promising to meet these standards. The principles involve monitoring the rate of decrease or increase of the EPR signal in vivo after injection of the nitroxide or the hydroxylamine probe, respectively, in a pathological versus a control situation. There have been many successful applications in various rodent models. However, current limitations lie in both the field of the technical development of the spectrometers and the molecular probes. The scope of this review will mainly focus on the latter.
1 October 2021 in Polymer Degradation and Stability
Nitroxides are potent tools for studying biological systems by electron paramagnetic resonance (EPR). Whatever the application, a certain stability is necessary for successful detection. Since conventional tetramethyl-substituted cyclic nitroxides have insufficient in vivo stability, efforts have recently been made to synthesize more stable, tetraethyl-substituted nitroxides. In our previous study on piperidine nitroxides, the introduction of steric hindrance around the nitroxide moiety successfully increased the resistance to reduction into hydroxylamine. However, it also rendered the carbon backbone susceptible to modifications by xenobiotic metabolism due to increased lipophilicity. Here, we focus on a new series of three nitroxide candidates with tetraethyl substitution, namely with pyrrolidine, pyrroline, and isoindoline cores, to identify which structural features afford increased stability for future probe design and application in in vivo EPR imaging. In the presence of rat liver microsomes, pyrrolidine and pyrroline tetraethyl nitroxides exhibited a higher stability than isoindoline nitroxide, which was studied in detail by HPLC-HRMS. Multiple metabolites suggest that the aerobic transformation of tetraethyl isoindoline nitroxide is initiated by hydrogen abstraction by P450-FeV = O from one of the ethyl groups, followed by rearrangement and further modifications by cytochrome P450, as supported by DFT calculations. Under anaerobic conditions, only reduction by rat liver microsomes was observed with involvement of P450-FeII.
The degradation behaviors of the encapsulant and the imbedded additives significantly determine the reliability of solar modules. Nevertheless, a link between the degradation of the encapsulant, including the additive interactions, and the longevity of the overall module is rarely established until now. Herein, mini‐modules containing ethylene‐vinyl acetate copolymer (EVA) as encapsulant are subject to damp heat (DH) or ultraviolet (UV) weathering based on IEC 61215. Macroscopically, the degradation under both weathering types characterized by I – V measurements and electroluminescence (EL) measurements is diverging in dependence on the used stressor. Using electron paramagnetic resonance and orbitrap mass spectrometry, it is shown that deacetylation of the EVA occurs significantly for both types of weathering. In the case of DH, however, the mechanism of action of the UV stabilizer is hindered, so that strong encapsulant degradation is observed despite a lower energy input in comparison with UV. Furthermore, the produced acetic acid under DH weathering leads to the observed reduction in EL, an increase in series resistance, and, a reduction of the performance of the modules. The work carried out shows that the degradation of the solar modules is strongly dependent on the behavior of the UV stabilizer.
This work is the first part of three studies dealing with the degradation of crystalline Si‐based solar modules depending on the chosen material combination, whereby the focus of this work is on encapsulant degradation. Within the paper, solar modules based on ethylene‐vinyl acetate (EVA) copolymer encapsulant and polyolefin elastomer (POE) encapsulant with different rear side encapsulations were artificially aged with UV irradiation (76.6 W/m 2 between 280 and 380 nm) in combination with 60% relative humidity at 85°C. In situ moisture measurements and simulations of oxygen diffusion were used to show how stressors are distributed in the module. Additive and polymer degradation was analyzed by the Fourier transform infrared spectroscopy (FTIR), Orbitrap mass spectrometry, and electron paramagnetic resonance (EPR). This approach made it possible to determine the degradation of the encapsulants in a spatially resolved manner depending on the presence of stressors and the consumption of additives. The findings reveal that degradation is heavily influenced by the microclimate within the module, which itself is affected by the material combinations used. It is shown that oxygen has a major influence on the degradation of POE, as it is essential for the formation of hydroperoxides. Furthermore, it becomes clear that EVA does not necessarily have to be inferior to the novel POE encapsulants if it is combined with the right rear side encapsulation.