In this study, investigation has been conducted in the focus of obtaining better surface finish in the electro discharge machining (EDM) of AZ91/5B4Cp magnesium composites using distinctive sort of anode viz. copper, tungsten–copper, brass, aluminum and 20Gr/AA6061 (GRAL-20) composites. The process parameters, pulse on time and current were performed to research the machining qualities through material removal rate (MRR) and tool wear rate (TWR). The machined composites were examined by optical microscopy (OM) and scanning electron microscopy (SEM). The formation of black spots was observed on machining with copper–tungsten and these black spots were not found when GRAL-20 was used as electrode. Machined with GRAL-20 electrode leads to the increase in spark gap, hence adequate flushing occurs; it eliminates re-melted layers on machined surface results in better surface roughness value. The results revealed that GRAL-20 electrodes posses better MRR followed by copper electrode whereas tungsten–copper exhibits better TWR followed by GRAL-20 electrode.
3 November 2018 in Journal of the Australian Ceramic Society
In this research work, medical grade titanium alloy Ti4Al6V was electric discharge machined with an objective of attaining mirror finish for orthopedic implants. Experiments were conducted by varying tool materials, discharge current, pulse on time and pulse off time whereas the responses chronicled are material removal rate, electrode wear rate and surface roughness. The aluminium (A), copper (C) and aluminium alloy reinforced with graphite particles of various weight percentage (5-A1,10-A2,15-A3) were used as tool materials. The composites were fabricated using stir casting technique. The findings showed that the titanium alloy machined with A1 composite tool offers the highest MRR, the C tool has the lowest EWR, and the A2 composite tool results in good surface finish. The surface of specimens produced using A1 tool exhibits poor surface quality owing to the eczema surface. Specimens machined with the C tool have a remelted layer, pockmarks, and an uneven fusion structure, which were not present in specimens machined with the A2 tool. MOORA-ELECTRE Integrated Optimization Technique (MEIOT) was applied to select the best parametric combination and the best electrode material.
27 August 2021 in Surface Topography: Metrology and Properties
Requirement of processes with high productivity leads to the development of new tools and machining technique. One such attempt was made to develop a Copper Composite (CC) tool reinforced with graphite particles through the stir casting route. The CC tool was utilized to machine the Inconel 718 alloy using Electric Discharge Machining (EDM) technique by varying input variables viz tool material, discharge current, pulse on time, pulse off time and gap distance. Brass, Copper, Copper—5% Graphite (CG5), Copper—10% Graphite (CG10), Copper—15% Graphite (CG15) are the various used tool material whereas Material Removal Rate (MRR), Tool Wear Ratio (TWR) and Surface Roughness (R a ) were recorded as responses. The results revealed that using the CG10 and CG15 tools causes arcing and open circuit under some parametric conditions. CG5 offers best MRR and least TWR owing to the bridging effect, high thermal conductivity and lesser density which was suitable for roughing operation whereas brass offers least R a which was recommended for finishing operation. The surface topography was analyzed with the aid of Scanning Electron Microscope (SEM). Micro crack, pock marks, globules and remelted layers are some of the defects observed in surface morphology. The process parameters was optimized using VIKOR technique.
24 August 2017 in Journal of the Australian Ceramic Society