Requirement of processes with high productivity leads to the development of new tools and machining technique. One such attempt was made to develop a Copper Composite (CC) tool reinforced with graphite particles through the stir casting route. The CC tool was utilized to machine the Inconel 718 alloy using Electric Discharge Machining (EDM) technique by varying input variables viz tool material, discharge current, pulse on time, pulse off time and gap distance. Brass, Copper, Copper—5% Graphite (CG5), Copper—10% Graphite (CG10), Copper—15% Graphite (CG15) are the various used tool material whereas Material Removal Rate (MRR), Tool Wear Ratio (TWR) and Surface Roughness (R a ) were recorded as responses. The results revealed that using the CG10 and CG15 tools causes arcing and open circuit under some parametric conditions. CG5 offers best MRR and least TWR owing to the bridging effect, high thermal conductivity and lesser density which was suitable for roughing operation whereas brass offers least R a which was recommended for finishing operation. The surface topography was analyzed with the aid of Scanning Electron Microscope (SEM). Micro crack, pock marks, globules and remelted layers are some of the defects observed in surface morphology. The process parameters was optimized using VIKOR technique.
24 August 2017 in Journal of the Australian Ceramic Society
Limitation in penetration depth is a concern in conventional TIG welding process. To improve penetration capability of TIG process, both Activated TIG (ATIG) and Flux Bounded TIG (FBTIG) are investigated in aluminum alloy AA 2219 T87. Undesirable arc wandering and cracking tendency are observed in ATIG welds. Microstructural investigation reveals ATIG welds are prone for liquation cracks. Morphology of the cracks along with the attributable factors are explained with optical and SEM (Scanning Electron Microscope) micrographs. Energy Dispersive Spectroscopy (EDS) results are also presented to explain the solute enrichment in the grain boundaries of the ATIG welds. FBTIG is found to produce good quality welds and is more suitable for welding aluminum alloys. Key words: Flux Assisted TIG; ATIG; FBTIG; Penetration Improvement; Microstructure; AA2219.