The pore structure and connectivity of coal are the primary factors influencing the permeability of coal reservoirs. However, clay and carbonate minerals are commonly found filling the pores and fractures within coal. To address the impact of these minerals on fracturing effectiveness, acidic fracturing technology has been introduced. This technique has proven to be an effective measure for enhancing the extraction rate of low-permeability coal seams with high mineral content. In this study, coal samples were treated with a 3% HCl solution, and the changes in the pore structure of the coal before and after acidification were analyzed through low-temperature nitrogen adsorption and X-ray diffraction (XRD) testing. The results were as follows: After acidification, the specific surface area, total pore volume, pore volume in different stages, and average pore size of the coal samples all significantly increased. Specifically, the BET specific surface area grew by an average of 4.8 times and the total pore volume expanded by an average of 7.7 times, with the pore volumes in the pore size ranges of <10 nm and 10–60 nm increasing by an average of 10.1 times and 7.7 times. The smoothness of the pore surface and connectivity of the pore structure in the coal samples improved, as indicated by decreased fractal dimensions D1 (reflecting pore surface roughness) and D2 (representing pore size distribution uniformity). The acidification mechanism was mainly attributed to the dissolution of carbonate minerals in the coal, which led to the removal of obstructive minerals such as ankerite and calcite that had accumulated in the coal pores. This resulted in the formation of new micropores and microfractures, achieving pore volume enhancement and pore expansion.
Considering the alarming frequency of coal mine gas disasters globally, there is an urgent need to develop efficient gas control technologies to ensure mining safety. This study focuses on the problem of high peak gas emission restriction in the process of coal roadway tunneling in outburst coal seams, taking the No. 15 outburst coal seam of the Pingshu Coal Mine as the research object. Based on coal sample testing analysis and the application of CO2 gas fracturing (CO2-Frac) in coal mines, a comprehensive evaluation was conducted on pore-fracture structure alteration and homogenization gas emission effect induced by CO2-Frac, providing technical solutions for coal mine safety production. The results are as follows: (1) CO2-Frac induces fracture propagation and the development of three types of fracture structures: Tri-Wing Fracture, Damage Markers, and Coal Matrix Fragmentation. (2) Following CO2-Frac at 150 MPa, the pore volume and average diameter of pores in the 100-10,000 nm range increased by 128% and 61%, respectively, compared to the pre-CO2-Frac state. (3) During the excavation period, continuous monitoring of the airflow for 3 days showed a significant homogenization of gas emission, with a maximum value of 0.450% and a variance value of 0.0031, indicating a reduction of 31% and 68%, respectively. These results reveal several key findings: The pore-fracture structure alteration enhances gas diffusion and permeation, providing high-speed pathways for gas migration, resulting in a substantial increase in gas extraction efficiency. During coal cutting, the modified coal exhibits homogenized gas emission, eliminating the high peak phenomenon and achieving safe and efficient mining. These findings demonstrate that CO2-Frac has broad potential in gas emission homogenization for widespread application in coal mines with similar gas geological conditions.