To enable precise manipulation of fragile objects, robots need the sense of touch. Localized sensing of the 3D force vector with a few mN of resolution is desired. Magnetic force sensors, consisting of a magnet embedded in an elastomer and a 3D magnetometer, were demonstrated as desirable candidates. These prior-art sensors measure the local 3D magnetic field at a single sensing pixel. Hence, they cannot distinguish between the signal and stray magnetic fields. Any stray field directly leaks into the force readout signal path. This letter introduces a design immune to stray magnetic fields. The sensor uses multiple magnetic pixels, and operates on the gradient of the magnetic field. The pixels and conditioning electronics are fully integrated on chip. The 3D force calculation is based on a polynomial model fitted to a calibration data set. The impact of a 2-mT magnetic stray field on the force output is limited to 0.3% of the full scale—about two orders magnitude improvement over the prior art. The force resolution is 2.7 mN and remains competitive. Furthermore, an on-chip temperature sensor and an algorithm are used to compensate the intrinsic thermal drift in the range 0–50 ${}^{\circ }$ C. To validate the proper force regulation in spite of a nearby magnet, we integrated our prototype into a robotic hand. Our results demonstrate the robustness of 3D magnetic force sensors in the presence of real-world parasitic disturbances.
The manipulation of delicate objects remains a key challenge in the development of industrial robotic grippers. Magnetic force sensing solutions, which provide the required sense of touch, have been demonstrated in previous work. The sensors feature a magnet embedded within a deformable elastomer, which is mounted on top of a magnetometer chip. A key drawback of these sensors lies in the manufacturing process, which relies on the manual assembly of the magnet–elastomer transducer, impacting both the repeatability of measurements across sensors and the potential for a cost-effective solution through mass-manufacturing. In this paper, a magnetic force sensor solution is presented with an optimized manufacturing process that will facilitate mass production. The elastomer–magnet transducer was fabricated using injection molding, and the assembly of the transducer unit, on top of the magnetometer chip, was achieved using semiconductor manufacturing techniques. The sensor enables robust differential 3D force sensing within a compact footprint (5 mm × 4.4 mm × 4.6 mm). The measurement repeatability of these sensors was characterized over multiple samples and 300,000 loading cycles. This paper also showcases how the 3D high-speed sensing capabilities of these sensors can enable slip detection in industrial grippers.
1 January 2026 in IEEE Transactions on Medical Robotics and Bionics