The formation of a columnar grain structure in high chromium nickel based alloy welds can be associated with cracking and poor resolution for ultrasonic non-destructive examination. The objective of this research was to characterise the effects of circular magnetic arc deflection (arc stirring) on grain structure of gas tungsten arc weld overlays made on Inconel 690 substrates with 52M filler wire. Welds and weld overlays were made at various arc stirring frequencies, and microstructures were analysed using optical and electron backscattered diffraction microscopy. Significant refinement of grain size occurred at a stirring frequency of 7 Hz. Ultrasonic non-destructive examination confirmed 100% improvement in signal/noise ratio in weld overlays made with magnetic stirring.

High-strength, low-alloy (HSLA) steel has attracted much attention in the manufacturing industry because of its good combination of high strength and toughness, low cost, and good formability. Wire and arc additive manufacturing (WAAM) technology can realize the rapid prototyping of HSLA steel parts. This study investigated a 26-layer HSLA steel component fabricated with the WAAM technique. The microstructure of the deposited wall of ER120S-G is mainly acicular ferrite, and there are longitudinal, preferentially growing dendrites along the deposition direction. With the deposition height accumulation, the top sample’s interlayer temperature increases and the amount of acicular ferrite in the microstructure decreases, while the amount of quasi-polygonal ferrite, Widmanstatten ferrite increases. The changes in microhardness were consistent with the corresponding microstructure gradients: the microhardness of the top sample showed a decreasing trend along the deposition direction, while the microhardness of the middle sample was uniform and stable. The present work shows that the mechanical properties of HSLA steel parts deposited using WAAM technology have good strength and toughness. The microstructure gradient of the sample along the deposition direction did not lead to a significant difference in the tensile strength of the sample at different heights. On the contrary, the ductility of the longitudinal sample is slightly lower than that of the transverse sample, indicating some anisotropy in the deposited sample, which is related to the directional growth of grains along the direction of heat flow. From the current work, the thin wall of HSLA steel prepared with the WAAM process has good mechanical properties, which indicates that it is feasible to replace the traditional processing method with the WAAM process to rapidly manufacture an HSLA steel structure meeting the performance requirements.