Seda Demirel Topel

Dr. Seda Demirel Topel

Electrical and Electronics Engineering, Antalya Bilim University, Antalya, Turkey (Türkiye)

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 April 2023 in Water
Verified
Journal Article
Open access
PDF file
AMamina mokeddem
amina mokeddem
SBSamir BENYKHLEF
Samir BENYKHLEF
ABAmine Ahmed Bendaoudi
Amine Ahmed Bendaoudi
NBNacer Boudouaia
Nacer Boudouaia
Hacene MahmoudiHacene Mahmoudi
Hacene Mahmoudi
ÖTÖnder Topel
Önder Topel
The present study aimed to investigate the adsorption capacity of two anionic dyes, namely, Congored (CR) and Coralene Dark Red2B (DR), onto prepared alginate (Alg) and chitosan(Cs) biopolymer films. The two biopolymers were combined at different mass ratios using a “solvent-cast” process to incorporate their unique properties and evaluate their effectiveness in removing the dyes. All samples were characterized by means of Fourier transform infrared spectroscopy (FTIR), differential scanning calorimetry (DSC), scanning electron microscopy (SEM) and determination of point of zero charge (pHpzc). The swelling ratios were determined by gravimetric measurements. The effects of pH, adsorption time, thickness, temperature and initial concentration of CR and DR dyes on the adsorption results were studied systematically. The dye adsorption kinetics showed that the Alg/Cs films at % proportions of 75/25, 50/50, 25/75 and 0/100 reached equilibrium from 30 min to 180 min with high removal efficiencies that varied between 222.30 mg/g and 842.36 mg/g. The adsorption mechanism of CR and DR onto the synthesized biofilms was confirmed through Langmuir isotherm and the kinetics fitted well by the pseudo-second-order model, suggesting a monolayer and chemisorption process. The thermodynamic results demonstrated the spontaneity and the feasibility of the process as well as the exothermic nature. Hence, the findings revealed that the Alg/Cs biofilms could be employed as potential natural adsorbents for the removal of anionic dye pollutants from aqueous environments.

30 April 2019 in Health Sciences Quarterly
Verified
Journal Article
Closed access
STSeda Demirel Topel
Seda Demirel Topel
TPTulin Gürkan Polat
Tulin Gürkan Polat
In the present study, polyethyleneimine (PEI) coated superparamagnetic iron oxide nanoparticles (SPIONs) having the size of 15 nm in diameter with high magnetic saturation (60 emu/g) have been prepared by co-precipitation method. The synthesized PEI-Fe3O4 nanoparticles have been fully characterized by transmission electron microscope (TEM), dynamic light scattering (DLS), Fourier transform infrared (FTIR) spectroscopy, X-ray photoelectron spectroscopy (XPS) and X-ray diffraction (XRD) techniques. The free amine groups on the PEI-Fe3O4 surface has been covalently functionalized with carboxymethyl cellulose (CMC) by the catalysis of N,N'-Dicyclohexylcarbodiimide (DCC) and N, N'-Dimethylpyridin-4-amine (DMAP) coupling to produce CMC-Fe3O4 nanocarriers. The prepared CMC-Fe3O4 nanocarriers have been loaded with a well-known anti-tumor drug doxorubicin (Dox) and investigated its loading and releasing profiles from the nanocarrier. The CMC acted as an excellent nanocarrier for Dox with a loading efficiency ≈ 86%. The drug releasing profile has been studied at different pH values (3.5; 5.5; and 7.4). When the pH of the release medium (phosphate buffer solution) was changed from 7.4 to 5.5 or 3.6, the drug release has been increased which indicates that the drug releasing is pH dependent.

28 October 2021 in Sensor Review
Verified
Journal Article
Closed access
STSeda Demirel Topel
Seda Demirel Topel
MBMustafa Beyaz
Mustafa Beyaz
Purpose: The purpose of this study is to develop a non-enzymatic based glucose-sensing platform composed of Bodipy-BBV dual system which can be monitored by a photodetector under the blue LED excitation. Design/methodology/approach: The sensor has been developed from a dual system including a fluorescent dye, an aldehyde derivative of boron dipyrromethene (Bodipy) and a quencher, orto-boronic acid linked viologen (o-BBV) where their combination resulted in a ratiometric fluorescence quenching in ethanol: PBS (1:1, pH:7.4) solution under UV light excitation. By glucose addition, o-BBV has been released from the Bodipy and binded to cis-diol groups of glucose, thereby fluorescence emission of Bodipy has been regained. Furthermore, a setup consisting of a light emitting diode (LED) and a photodiode (PD) was used to prove electrical detection of glucose without the need for expensive and bulky optical equipment, enabling the development of a miniaturized and low-cost glucose-sensing platform. Findings: The fluorescence intensity of the Bodipy derivative in the solution (2 × 10−6 M) was diminished by 93% in the presence of o-BBV solution (5 × 10−3 M). Upon the glucose addition, 81% of the Bodipy fluorescence intensity has been recovered after introduction of 30 mM of glucose, where the ratio of o-BBV/Bodipy was 35:1. A linear response between 10 and 30 mM glucose concentration was obtained, which covers the biologically significant range. A high correlation between the photodiode current and Bodipy fluorescence intensity was achieved. Originality/value: Even though Bodipy molecules are known with their superior optical properties and applied to the fluorescence-based detection of glucose, to the best of the authors’ knowledge, no work has been reported on Bodipy-BBV dual system to detect glucose molecules as a non-enzymatic based method. This design enables the dye and the quencher to independently coexist in the solution, allowing for tuning of their individual concentrations to optimize the glucose sensitivity. Furthermore, an electrical light detection scheme consisting of a LED and a photodiode has been implemented to eliminate the bulky optical equipment from the measurement setup and further this work for the development of a compact and inexpensive sensor. The results presented here demonstrate the feasibility of this system for the development of a novel glucose sensor.

12 December 2023 in Journal of Applied Polymer Science
Verified
Journal Article
Closed access
VKViktoriia Kyshkarova
Viktoriia Kyshkarova
DBDominika Marcin Behunová
Dominika Marcin Behunová
Inna V. MelnykInna V. Melnyk
Inna V. Melnyk
STSeda Demirel Topel
Seda Demirel Topel

20 September 2024 in Engineering Proceedings
Verified
Conference Paper
Open access
PDF file
MAMenduh Furkan Aslan
Menduh Furkan Aslan
CÖCem Özbek
Cem Özbek
Gökhan YiğitGökhan Yiğit
Gökhan Yiğit
MTMehmet Tosun
Mehmet Tosun
STSeda Demirel Topel
Seda Demirel Topel
The prolonged issue of poor posture due to desk work has led to innovative technological remedies. This study shows the development of a flexible piezoelectric biosensor integrating BaTiO3 nanoparticles within a Polydimethylsiloxane (PDMS) matrix for practical posture correction. The biosensor is capable of real-time posture monitoring and correction by leveraging the piezoelectric properties of BaTiO3. Comprehensive synthesis and characterization using X-ray diffraction analysis (XRD) and transmission electron microscopy (TEM) validated the ideal particle size and crystalline structure of the composite. COMSOL Multiphysics simulations showed a peak potential of 0.87 volts under mechanical stress, which further confirmed the sensor’s efficiency. Electrical testing revealed that the sensor with 35 wt.% BaTiO3 exhibited a higher output voltage of 0.87 V compared to 0.34 V for the sensor with 30 wt.% BaTiO3, emphasizing its exceptional potential for addressing posture-related issues.

29 December 2023 in TURKISH JOURNAL OF CHEMISTRY
Verified
Journal Article
Open access
PDF file
STSeda Demirel Topel
Seda Demirel Topel
This study aimed to investigate the photocatalytic and photodynamic actions of a 2,6-diiodinated-BODIPY (2,6-diI2-Bod) photosensitizer (PS) covalently linked to TiO2 nanoparticles (NPs). The TiO2 NPs were synthesized utilizing the hydrothermal technique, yielding an average particle size of 4–5 nm as ascertained by transmission electron microscopy and 6.4 nm as determined by dynamic light scattering measurements. The integration of the nonsoluble Bod PS to TiO2 NPs provided increased dispersibility in physiological media, making it more applicable to photodynamic therapy applications. Bod-TiO2 NPs exhibited moderate efficiency of 56.9% in singlet oxygen generation. Additionally, the photocatalytic behavior of the TiO2 NPs was evaluated using methylene blue and 83.8% photodegradation efficiency was observed. The loading efficiency and loading content of the Bod PS were found to be 90.8% and 54.5%, respectively. These results suggest that Bod-TiO2 NPs possess higher dispersibility in aqueous solutions, moderate photocatalytic activity, and potential for photodynamic therapy applications.