It is well known that biofouling increases a ship’s resistance and nominal wake. For submarines, any change to the circumferential variation of the nominal wake in the propeller plane will affect the variation of the flow over the propeller blade, and hence the fluctuating forces, and noise, generated by the propeller. The ANSYS FLUENT commercial Reynolds-Averaged Navier Stokes Computational Fluid Dynamics solver was used to investigate the influence of both the longitudinal and vertical distribution of biofouling on the resistance and wake, including the circumferential variation of the nominal wake, on a submarine, using the well-known Suboff standard submarine. For the present work, the k-ε turbulence model was selected, as this is commonly used in this field and is generally considered acceptable. To handle different boundary layer thicknesses in the flow fields, the whole y+ formulation was employed, enabling automatic switching between low and high Reynolds boundary wall models. The numerical solver used for the simulations is based on the finite volume method, which discretizes the RANS equations. In this approach, a segregated model was utilized in the solver, and the convection terms were discretized using the second-order upwind scheme to enhance solution accuracy. The criteria for the near wall are between 30 and 100, and the value of y+ for the present case is 84. It is shown that fouling over only the forward third of the submarine results in a greater increase in resistance than fouling over only the aft third. Fouling over only the lower half of the submarine results in greater resistance than fouling over only the forward third, but less than fouling over the whole of the hull. Fouling over only the forward third of the hull has less influence on the circumferential variation of the wake than fouling over the aft third only of the hull. The results show the importance of keeping the forward area of the hull clean when considering resistance only, whereas keeping the aft area of the hull clean is important when considering the uniformity of the nominal wake into the propeller.
The response of a ship or other vessel to surface sea waves, including extreme waves, may compromise crew and vessel safety and long-term operational capability. Herein, a novel high-fidelity numerical time-dependent simulation approach is presented using Smoothed Particle Hydrodynamics (SPH) for modelling sea waves coupled with Finite Element Analysis for modelling vessel structural response under wave loading conditions. The results are compared with physical scale model wave tank test results. Good agreement was obtained for heave and pitch motions and vertical bending moments for various forward (head) speeds in regular head waves, heave and pitch motions, and vertical bending moments. High computational demands can be met by the increasing availability of computation power. Ongoing research is outlined. The implications for the design of vessels such as ships and for through-life assessment are discussed.
31 May 2023 in Journal of Marine Science and Technology
At the early design stage of a submarine, it is necessary to have a good estimate of the linear manoeuvring coefficients, or derivatives. These are necessary to determine the required size of any appendages to achieve the desired level of motion stability and controllability. Various empirical methods exist to make such estimates, including the influence of appendages. However, methods do not exist to predict the linear rotary coefficients (i.e. $${Y}_{r}^{^{\prime}}$$ and $${N}_{r}^{^{\prime}}$$ ) for a bare hull. Thus, the aim of this work was to determine the values of the linear rotary coefficients for an axisymmetric underwater body as functions of Length to Diameter (L/D) ratio to improve the empirical estimate of these values for a fully appended submarine. The work was performed using validated Reynolds Averaged Navier Stokes (RANS) based simulations to obtain forces and moments on the body. It is considered that the developed expressions for the linear rotary coefficients are adequate for an unappended axisymmetric underwater body at the design stage over the range: 6 ≤ L/D ≤ 14, which can then be used to size and locate the appendages.