There is an ongoing search for novel disinfection techniques that are not only effective, cheap, and convenient, but that also do not have adverse effects on the properties of dental impressions. We compared the effects of various methods (UVC, gaseous ozone, commercial solution, and spray) on the dimensional change, tensile strength, and hardness of silicone impressions. Moreover, as a secondary aim, we performed a statistical comparison of the properties of nondisinfected addition (Panasil Putty Soft, Panasil monophase Medium, Panasil initial contact Light) and condensation silicones (Zetaplus Putty and Oranwash L), as well as a comparison of materials of various viscosities (putty, medium-bodied, and light-bodied). Our results revealed that addition silicones had higher dimensional stability, tensile strength, and Shore A hardness compared to condensation silicones. Both traditional (immersion and spraying) and alternative methods of disinfection (UVC and ozone) had no significant impact on the tensile properties and dimensional stability of the studied silicones; however, they significantly affected the hardness, particularly of Oranwash L. Our study demonstrated that, similarly to standard liquid disinfectants, both UVC and ozone do not strongly affect the material properties of most silicones. However, before recommendation, their usefulness for each individual material should be thoroughly evaluated.

Effective disinfection of dental impressions is an indispensable requirement for the safety of dental personnel and patients. The ideal method should be not only effective but also convenient, cheap, and environmentally friendly. This study aimed to reliably evaluate the efficacy of ultraviolet C (UVC) radiation, gaseous ozone, and commercial liquid chemicals used for silicone dental impressions disinfection. These methods were applied to two types of elastomeric impression materials: condensation silicones and addition silicones of various consistency (putty, medium, and light). The antimicrobial effectiveness against Pseudomonas aeruginosa, Staphylococcus aureus, and Candida albicans was evaluated in vitro by counting colony-forming units (CFU) on the surface of samples. The one-way ANOVA with a Tukey HSD test or the Kruskal–Wallis with a Dunn’s test was performed. The results obtained revealed the efficacy of the proposed methods for disinfection of both C-silicones and A-silicones in most of the studied groups. Only one material (Panasil initial contact Light) was not effectively disinfected after UVC irradiation or ozone application. In conclusion, the potential of each disinfection method should be evaluated separately for each material. Moreover, in further research, the possible influence of the proposed methods on the physical properties of the impression materials should be thoroughly investigated.