This paper shows the implementation of the Moth–Flame Optimization algorithm in a Cascade-H multilevel inverter with five and seven levels to determine the optimal switching sequence of the inverter’s semiconductor devices. The algorithm was coded in Matlab software, and the obtained switching sequences were implemented in a Cascade-H multilevel inverter laboratory prototype, where the output voltage waveform was obtained using a digital oscilloscope. The experimental Total Harmonic Distortion was obtained using a power quality analyzer. The experimental results show the improvement of the Total Harmonic Distortion in the voltage output. These results were compared with other papers in the literature with different metaheuristic methods concerning the same modulation. These findings demonstrate the feasibility of employing the Moth–Flame Optimization Algorithm to significantly reduce the Total Harmonic Distortion, obtaining a lower value than most analyzed papers.

In this work, a numerical analysis of three different flat plate solar collectors was conducted using their entropy generation rates. Specifically, the Computational Fluid Dynamics (CFD) technique was used to compare the detailed performance of conventional and zigzag tube geometries of flat plate solar collectors (FPCs) in terms of their entropy generation rates. The effects of fluid viscosity, heat transfer, and heat loss of the flat plate solar collectors were considered for the local and global entropy generation rate analyses. Variations on the inlet volumetric flow rate of the FPCs from 1.0 to 9.0 L/min were simulated under the average solar radiation for one year in the state of Guanajuato, Mexico. The results illustrate and discuss the temperatures, pressures, and global entropy generation rates for volumetric flow variations. The velocity, temperature, and pressure distributions and the maps of the local entropy generation rates inside the collectors are presented and analyzed for the case with a flow rate of 3.0 L/min. These results demonstrate that the zigzag geometries achieved higher outlet temperatures and greater entropy generation rates than the conventional geometry for all the volumetric flow rates considered.