Recently, there has been a growing need for sensors that can operate autonomously without requiring an external power source. This is especially important in applications where conventional power sources, such as batteries, are impractical or difficult to replace. Self-powered sensors have emerged as a promising solution to this challenge, offering a range of benefits such as low cost, high stability, and environmental friendliness. One of the most promising self-powered sensor technologies is the L–S TENG, which stands for liquid–solid triboelectric nanogenerator. This technology works by harnessing the mechanical energy generated by external stimuli such as pressure, touch, or vibration, and converting it into electrical energy that can be used to power sensors and other electronic devices. Therefore, self-powered sensors based on L–S TENGs—which provide numerous benefits such as rapid responses, portability, cost-effectiveness, and miniaturization—are critical for increasing living standards and optimizing industrial processes. In this review paper, the working principle with three basic modes is first briefly introduced. After that, the parameters that affect L–S TENGs are reviewed based on the properties of the liquid and solid phases. With different working principles, L–S TENGs have been used to design many structures that function as self-powered sensors for pressure/force change, liquid flow motion, concentration, and chemical detection or biochemical sensing. Moreover, the continuous output signal of a TENG plays an important role in the functioning of real-time sensors that is vital for the growth of the Internet of Things.
This study aimed to develop a simple but effective mechanical-to-electrical energy conversion for harvesting hydrokinetic energy based on triboelectric nanogenerator (TENG) technology. Here, a direct-current fluid-flow-based TENG is reported as a potential solution to solve the inconvenience of directly powering electronic devices where direct-current (DC) power is required. The falling of a water droplet (about 1.06 mL) from an elastomeric pipe can generate an open-circuit voltage of ~35 V, short-circuit current of 3.7 µA, and peak power of 57.6 µW by passing through a separated electrode. Notably, the electrical responses have the distinct characteristics of pulsed direct current. The ability to generate DC outputs enables the TENG to directly drive electronic devices. Our experimental results prove that this TENG can act as a power source to directly light up 50 light-emitting diodes without requiring a rectifier, and, also, the produced electric energy was demonstrated that can be stored directly in a capacitor to power commercial temperature and humidity IoT sensors. Furthermore, the device shows a greatly varied output voltage based on the droplet flow rate, with a linearity R2 = 0.998. This work highlights a promising potential for applications in harvesting hydrokinetic energy and self-powered sensors and systems.
Recently, triboelectric nanogenerators (TENGs) have emerged as having an important role in the next wave of technology due to their large potential applications in energy harvesting and smart sensing. Recognizing this, a device based on TENGs, which can solve some of the problems in the liquid flow measurement process, was considered. In this paper, a new method to measure the liquid flow rate through a pipe which is based on the triboelectric effect is reported. A single-electrode flowing liquid-based TENG (FL-TENG) was developed, comprising a silicon pipe and an electrode coated with a polyvinylidene fluoride (PVDF) membrane. The measured electrical responses show that the FL-TENG can generate a peak open-circuit voltage and peak short-circuit current of 2.6 V and 0.3 µA when DI water is passed through an 8 mm cell FL-TENG at a flow rate of 130 mL/min and reach their maximum values of 17.8 V–1.57 µA at a flow rate of 1170 mL/min, respectively. Importantly, the FL-TENG demonstrates a robust linear correlation between its electrical output and the flow rate, with the correlation coefficient R2 ranging from 0.943 to 0.996. Additionally, this study explores the potential of the FL-TENG to serve as a self-powered sensor power supply in future applications, emphasizing its adaptability as both a flow rate sensor and an energy harvesting device.