A 37-mm-diameter split Hopkinson pressure bar (SHPB) apparatus was used for impact loading tests to determine the effects of the relative density and moisture content on the dynamic properties of coral sand. The stress–strain curves in the uniaxial strain compression state were obtained for different relative densities and moisture contents under strain rates between 460 s−1 and 900 s−1. The results indicated that with an increase in the relative density, the strain rate becomes more insensitive to the stiffness of the coral sand. This was attributed to the variable breakage-energy efficiency at different compactness levels. Water affected the initial stiffening response of the coral sand, and the softening was correlated with the strain rate. Strength softening due to water lubrication was more significant at higher strain rates due to the higher frictional dissipation. The volumetric compressive response of the coral sand was investigated by determining the yielding characteristics. The form of the constitutive model has to be changed to the exponential form, and different stress–strain responses should be considered. We discuss the effects of the relative density and water content on the dynamic mechanical properties of coral sand and clarify the correlation with the strain rate.
1 January 2022 in Science and Engineering of Composite Materials
The characteristic of interphase has a significant influence on the macroscopic performance of carbon fiber-reinforced plastics (CFRP). To investigate the effect of interphase on composite elastic modulus, a representative volume element (RVE) of unidirectional CFRP with inhomogeneous interphase was established. Based on the bridging model, a theoretical calculation method of composite elastic modulus was given. The elastic modulus of T300/BSL914C composites was obtained by the theoretical method. Results are in good agreement with the finite element method and experimental data. Four types of interphase models were given including inhomogeneous transversely isotropic, inhomogeneous isotropic, homogeneous transversely isotropic, and homogeneous isotropic. The results demonstrate that interphase type has an influence on the prediction of CFRP composites’ elastic modulus. With the increase of thickness, the prediction error of elastic modulus caused by interphase type increases rapidly. Furthermore, the relationship between composite elastic modulus and interphase thickness and stiffness is analyzed. With the increase in thickness, the changes in shear modulus G12 and Poisson’s ratio ν 23 are more evident than in other elastic properties, and with the enhancement of interphase stiffness, the increase of G12 is the most significant.
The mass erosion of the kinetic energy of projectiles penetrating concrete targets at high speed is an important reason for the reduction in penetration efficiency. The heat generation and heat conduction in the projectile are important parts of the theoretical calculation of mass loss. In this paper, theoretical models are established to calculate the mass erosion and heat conduction of projectile noses, including models of cutting, melting, the heat conduction of flash temperature, and the conversion of plastic work into heat. The friction cutting model is modified considering the heat softening of metal, and a model of non-adiabatic processes for the nose was established based on the heat conduction theory to calculate the surface temperature. The coupling numerical calculation of the erosion and heat conduction of the projectile nose shows that melting erosion is the main factor of mass loss at high-speed penetration, and the mass erosion ratio of melting and cutting is related to the initial velocity. Critical velocity without melting erosion and a constant ratio of melting and cutting erosion exists, and the critical velocities are closely related to the melting temperature. In the process of penetration, the thickness of the heat affected zone (HAZ) gradually increases, and the entire heat conduction zone (EHZ) is about 5~6 times the thickness of the HAZ.
In practice, the crack in some engineering materials is often compound crack. Therefore, it is important engineering significance to study on fracture problem. Based on the shape change energy near crack tip portion, the area fracture criterion of Iso-εθ line for compound crack was proposed. A crack initiation angle formula and the fracture criterion were established. The results showed that the theoretical predicted values and the measured values are consistent. The compound crack fracture line area of fracture criterion was established.Tthe formulas are easy to be derived and convenient to apply.