Danfeng Qiu

Dr. Danfeng Qiu

orcid

Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 July 2019 in Applied Sciences
Verified
Journal Article
Open access
PDF file
XMXiao Ma
Xiao Ma
DQDanfeng Qiu
Danfeng Qiu
QTQing Tao
Qing Tao
DZDaiyin Zhu
Daiyin Zhu
Due to its accuracy, simplicity, and other advantages, the Kalman filter method is one of the common algorithms to estimate the state-of-charge (SOC) of batteries. However, this method still has its shortcomings. The Kalman filter method is an algorithm designed for linear systems and requires precise mathematical models. Lithium-ion batteries are not linear systems, so the establishment of the battery equivalent circuit model (ECM) is necessary for SOC estimation. In this paper, an adaptive Kalman filter method and the battery Thevenin equivalent circuit are combined to estimate the SOC of an electric vehicle power battery dynamically. Firstly, the equivalent circuit model is studied, and the battery model suitable for SOC estimation is established. Then, the parameters of the corresponding battery charge and the discharge experimental detection model are designed. Finally, the adaptive Kalman filter method is applied to the model in the unknown interference noise environment and is also adopted to estimate the SOC of the battery online. The simulation results show that the proposed method can correct the SOC estimation error caused by the model error in real time. The estimation accuracy of the proposed method is higher than that of the Kalman filter method. The adaptive Kalman filter method also has a correction effect on the initial value error, which is suitable for online SOC estimation of power batteries. The experiment under the BBDST (Beijing Bus Dynamic Stress Test) working condition fully proves that the proposed SOC estimation algorithm can hold the satisfactory accuracy even in complex situations.

4 December 2014 in Journal of Solid State Electrochemistry
Verified
Journal Article
Closed access
PDF file
DQDanfeng Qiu
Danfeng Qiu
GBGang Bu
Gang Bu
BZBin Zhao
Bin Zhao
ZLZixia Lin
Zixia Lin

10 September 2018 in Discover Nano
Verified
Journal Article
Open access
PDF file
DQDanfeng Qiu
Danfeng Qiu
XMXiao Ma
Xiao Ma
JZJindong Zhang
Jindong Zhang
ZLZi-Xia Lin
Zi-Xia Lin
BZBin Zhao
Bin Zhao
Sodium-ion batteries have been widely used in energy storage owing to its high sodium content and low cost. This study proves that mesoporous silicon microspheres (MSMs) with the homogeneously distributed mesopores ranging from 1 to 10 nm can be used as anodes of NIBs. In situ magnesiothermic reduction of silicon oxide was carried out to synthesize the MSM samples. An anode in NIBs was tested, and it was observed that the MSMs sample which was calcined at 650 °C had a good rate performance of 160 mAh g−1 at 1000 mAg−1 and a high reversible capacity of 390 mAh g−1 at 100 mAg−1 after 100 cycles. Moreover, its long-term cycling performance was 0.08 mAh g−1 decay per cycle for 100 cycles, which was quite excellent. MSMs have high reversibility, good cycling performance, and excellent rate capability, which are related to its ultrafine particle size and mesoporous morphology.

9 December 2014 in RSC Advances
Verified
Journal Article
Closed access
PDF file
DQDanfeng Qiu
Danfeng Qiu
GBGang Bu
Gang Bu
BZBin Zhao
Bin Zhao
ZLZixia Lin
Zixia Lin
Nickel oxide (NiO) nanoparticles were directly formed on graphene nanosheets through in situ thermal decomposition of Ni(NO3)2·6H2O and were anchored tightly on the graphene surface. During the charge–discharge process, graphene nanosheets served as a three-dimensional conductive network for the NiO nanoparticles. The lithiation-induced strain was naturally accommodated because of the constraint effect of graphene. Thus, pulverization of NiO nanoparticles was effectively prevented.

1 September 2018 in International Journal of Electrochemical Science
Verified
Journal Article
Open access
DQDanfeng Qiu
Danfeng Qiu
XMXiao Ma
Xiao Ma
JZJingdong Zhang
Jingdong Zhang
ZLZixia Lin
Zixia Lin
BZBin Zhao
Bin Zhao

4 September 2026 in Electronics
Verified
Journal Article
Open access
PDF file
JMJinlong Ma
Jinlong Ma
XCXin Chen
Xin Chen
DQDanfeng Qiu
Danfeng Qiu
YJYingdan Jiang
Yingdan Jiang
WWWenxun Wei
Wenxun Wei
DZDaiyin Zhu
Daiyin Zhu
This paper proposes an on-chip time-to-digital converter (TDC) named pulse delay and capture circuit (PDCC), dedicated to single-event transient (SET) pulse measurement for radiation characterization of flash-based FPGAs. To address the inherent trade-offs of mainstream vernier delay line (VDL) and snapshot TDC schemes, the proposed PDCC employs a 16-stage single-chain self-triggering capture circuit with a SET indicator flip-flop, incorporates heterogeneous-cell ring-oscillator-based process-voltage-temperature (PVT) calibration, and avoids the need for resource-intensive first-in-first-out (FIFO) buffers. Implemented on a 130 nm A3PE600 flash-based FPGA, the PDCC achieves a nominal theoretical resolution of 640 ps and a nominal theoretical dynamic range of 0.64–10.24 ns, with 53.5% lower logic resource overhead than the VDL benchmark. Heavy-ion irradiation experiments validate the measurement capability and reveal asymmetric SET pulse propagation evolution characterized by positive-pulse broadening and negative-pulse attenuation, as well as sensitivity disparities among logic gates, which are attributed to the physical implementation of internal transistor networks within the VersaTile. A multi-criteria assessment based on the Simple Additive Weighting (SAW) method, evaluating resolution, dynamic range, logic resource overhead, and measured SET pulse width, yields an overall performance score (OPS) of 1.43, corresponding to a 43% higher score relative to the VDL baseline.