La2O3 films were grown on Si substrates by atomic layer deposition technique with different thickness. Crystallization characteristics of the La2O3 films were analyzed by grazing incidence X-ray diffraction after post-deposition rapid thermal annealing treatments at several annealing temperatures. It was found that the crystallization behaviors of the La2O3 films are affected by the film thickness and annealing temperatures as a relationship with the diffusion of Si substrate. Compared with the amorphous La2O3 films, the crystallized films were observed to be more unstable due to the hygroscopicity of La2O3. Besides, the impacts of crystallization characteristics on the bandgap and refractive index of the La2O3 films were also investigated by X-ray photoelectron spectroscopy and spectroscopic ellipsometry, respectively.
In this paper, the effects of Cu insertion layer and rapid thermal annealing on the resistive switching behaviors of La-based resistive switching access memory (RRAM) devices have been investigated. Compared with the undoped control sample (Cu/LaAlO3/Pt), the Cu-embedded devices show higher device yield and reset stop voltage, which indicates that the reliability of La-based RRAM has been effectively improved. However, the unannealed Cu/LaAlO3: Cu/Pt RRAM device still suffers from serious dispersion of parameters. It was proved that the RRAM device with Cu insertion layer and annealing treatment exhibits the best resistive switching characteristics such as low forming voltage, high on/off ratio and fine electrical uniformity. These improvements can be attributed to the diffusion of Cu atoms and the formation of Cu nanocrystals (Cu-NCs) after annealing process, since the diffused Cu atoms and the Cu-NCs could enhance the local electric field and weaken the randomness of the formation/rupture of conductive filaments.
Effects of the La2O3 passivation layer thickness on the interfacial properties of high-k/Ge interface are investigated systematically. In a very thin range (0~15 cycles), the increase of La2O3 passivation layer deposition cycles improves the surface smoothness of HfO2/Ge structures. The capacitance-voltage (C-V) characteristics show that the thickness of La2O3 passivation layer can affect the shift of flat band voltage (VFB), hysteretic behaviors, and the shapes of the dual-swept C-V curves. Moreover, significant improvements in the gate leakage current and breakdown characteristics are also achieved with the increase of La2O3 interlayer thickness.
The mechanism of flat band voltage (VFB) shift for alternate La2O3/Al2O3 multilayer stack structures in different annealing condition is investigated. The samples were prepared for alternate multilayer structures, which were annealed in different conditions. The capacitance-voltage (C-V) measuring results indicate that the VFB of samples shift negatively for thinner bottom Al2O3 layer, increasing annealing temperature or longer annealing duration. Simultaneously, the diffusion of high-k material to interfaces in different multilayer structures and annealing conditions is observed by X-ray photoelectron spectroscopy (XPS). Based on the dipole theory, a correlation between the diffusion effect of La towards bottom Al2O3/Si interface and VFB shift is found. Without changing the dielectric constant k of films, VFB shift can be manipulated by controlling the single-layer cycles and annealing conditions of alternate high-k multilayer stack.
Atom probe has been developed for investigating materials at the atomic scale and in three dimensions by using either high-voltage (HV) pulses or laser pulses to trigger the field evaporation of surface atoms. In this paper, we propose an atom probe setup with pulsed evaporation achieved by simultaneous application of both methods. This provides a simple way to improve mass resolution without degrading the intrinsic spatial resolution of the instrument. The basic principle of this setup is the combination of both modes, but with a precise control of the delay (at a femtosecond timescale) between voltage and laser pulses. A home-made voltage pulse generator and an air-to-vacuum transmission system are discussed. The shape of the HV pulse presented at the sample apex is experimentally measured. Optimizing the delay between the voltage and the laser pulse improves the mass spectrum quality.