Kamran Saeidi

Dr. Kamran Saeidi


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 February 2019 in Metals
Verified
Journal Article
Open access
PDF file
KSKamran Saeidi
Kamran Saeidi
SASajid Alvi
Sajid Alvi
FLFrantišek Lofaj
František Lofaj
VPValeri Ivanov Petkov
Valeri Ivanov Petkov
FAFarid Akhtar
Farid Akhtar
Duplex stainless steel, 71 wt.% austenite, 13 wt.% ferrite and 16 wt.% sigma, was made upon heat treating of fully ferritic as-built selective laser melted (SLM) 2507 stainless steel at 1200 °C. Formation of sigma phase in the heat treated SLM 2507 was investigated using optical microscopy and scanning electron microscopy (SEM). The heat treated SLM 2507 demonstrated a yield strength of 686 MPa, ultimate tensile strength of 920 MPa and an elongation of 1.8% at room temperature with a brittle fracture morphology. Precipitation of sigma phase during heat treatment and slow cooling improved the mechanical and wear properties at high temperatures (1200 °C and 800 °C, respectively). The tensile strength and elongation of the heat treated SLM 2507 was measured 400 MPa and 20% as compared to casted duplex steel with 19 MPa and 30% elongation at 1200 °C. The 20 times higher mechanical strength as compared to casted duplex steel was attributed to sigma precipitates. Tribological behaviour of heat treated duplex SLM 2507 containing sigma at 800 °C showed very low wear rate of 4.5 × 10−5 mm3/mN compared to casted duplex steel with 1.6 × 10−4 mm3/mN.

13 February 2019
Verified
Book Chapter
Open access
PDF file
KSKamran Saeidi
Kamran Saeidi
FAFarid Akhtar
Farid Akhtar
Stainless steels are widely used in chemical, structural and automotive applications due to their high room-temperature mechanical properties, toughness, corrosion resistance and low cost. However, tendency and rise in industrial demands for components to be used at high temperature with good mechanical performance and corrosion resistance limit their usage in many applications and narrow down their service criteria. Tailoring the microstructure, tuning the chemistry, adjusting the phase composition and introducing a dense 3D network of dislocations can tailor and develop stainless steels with high performance for extreme conditions, such as elevated temperatures. In this chapter, the effect of the microstructure of additively manufactured and thermo-mechanically processed stainless steels on the high temperature mechanical performance is discussed and a comparison is made with conventional steels. Moreover, new mechanisms are introduced and discussed co-relating the microstructure and properties.