In response to the heightened awareness of infectious diseases and the growing emphasis on personal protection in daily life, the utilization of natural bioresources for textile fabric dyeing has garnered substantial research attention. This is particularly due to their ability to confer antibacterial and UV protection properties to fabrics. In this study, the dyeing properties of Mimusops elengi Linn extract, alone and mordanted, were evaluated on blended wool/acrylic and silk fabrics, along with an assessment of their antibacterial and UV protection characteristics. The dyed fabrics exhibited good color strength and color fastness. Quantitative assessment of antibacterial activity was conducted using the reduction percentage test, while UV protection properties were determined through the measurement of Ultraviolet Protection Factor (UPF). Aqueous extract alone, when applied to blended wool/acrylic fabric, demonstrated an impressive 99.88 % reduction against Staphylococcus aureus, and 48.33 % for silk fabric, albeit less effective against Escherichia coli. Notably, when fabrics were dyed with a combination of leaves extract and various metal salt mordants, a substantial improvement in antibacterial properties was observed. Zinc and copper salts, in particular, exhibited the ability to enhance antibacterial properties to almost 100 % against Staphylococcus aureus and Escherichia coli in both blended wool/acrylic and silk fabrics. Concurrently, this combination contributed to an increase in the UV protection property of both fabrics. The findings underscore the potential of plant-based natural dye for blended wool/acrylic and silk fabrics, imparting antimicrobial and UV protection properties. This has significant implications in preventing the spread of infections and skin diseases, emphasizing the vital role of such textiles in promoting health and well-being.

Jute is a ligno-cellulosic natural fiber that ranks second in terms of the volume of cellulosic fibers and is extensively utilized for technical textile applications. The goal of this study is to determine the flame-retardance (FR) properties of pure Jute and Jute-Cotton fabrics treated with Pyrovatex CP New at concentrations of 90% (owf), M:L: 1:7. Both fabrics exhibited a substantial improvement in flame-retardancy. After the ignition period, the recorded flame spread time in both FR treated fabrics was zero seconds; whereas for untreated Jute and Jute-Cotton fabrics, the flame spread time was measured 21 s and 28 s, respectively, to burn their entire length (15 cm). Within these flame-spread times, the length of the char was 2.1 cm and 2.57 cm in the Jute and Jute-Cotton fabrics, respectively. After FR finishing, on both fabrics in the warp and weft directions, the physico-mechanical properties significantly decreased. The deposition of flame-retardant finishes on the fabric surface was determined by Scanning Electron Microscope (SEM) images. According to Fourier Transform Infra-Red Spectroscopy (FTIR) analysis, the flame-retardant chemical had no effect on the inherent properties of the fibers. Thermogravimetric analysis (TGA) analysis revealed that FR treated fabrics had early degradation, resulting in the formation of more char than in the untreated samples. After FR treatment, both fabrics showed a significant improvement in residual mass (more than 50%). Although the formaldehyde content observed in the FR treated samples was significantly greater, it was still within the permitted limit formaldehyde content in textiles intended for outerwear and not worn next to the skin. The results of this investigation demonstrate the potential use of Pyrovatex CP New in jute-based materials.