The purpose of this study was to attempt the encapsulation of lemongrass (Cymbopogon citratus) essential oil utilizing spray drying technique. An array of process parameters including concentration of wall (15–30%), type of wall materials (maltodextrin, maltodextrin and gum Arabic mixture), and concentration of essential oil (0.5–2.0%) were thoroughly investigated. The results show that the use of sole maltodextrin as encapsulant gave microcapsules characteristics comparable to that of powder produced using maltodextrin and gum Arabic mixture. The encapsulation process that was performed with maltodextrin at the concentration of 30% as wall material and lemongrass essential oil at the concentration of 1.5% as core material showed highest drying yield (84.49%), microencapsulation yield (89.31%) and microencapsulation efficiency (84.75%). Encapsulated essential oils retained most of their major constituents in comparison with the bare essential oils without any significant compromise in product quality.

In this study, we attempted the preparation of gac oil-loaded solid lipid nanoparticles (SLNs) by the high-speed homogenization method using Naterol SE solid lipid, a cosmetic self-emulsifying base, and surfactant and investigated the effects of different conditions on the characteristics of the resulting nanoparticles. The suspensions containing 5% active agents (gac-oil, w/w) were dispersed in a surfactant concentration of 5% (w/w) (Span 80:Tween 80 ratio of 28:72 w/w) and 2.5% (w/w) of solid lipid (Naterol SE) concentration. Suitable conditions for hot homogenization were 13,000 rpm, 60 min and 60 °C for speed, time and temperature, respectively. The suitable conditions for the subsequent cold homogenization were 25 min of homogenization time and 5 °C of temperature. The results showed that the mean size of SLNs-gac oil was 107 nm (measured by laser diffraction spectrometry, LDS), and dried size of SLNs-gac oil ranged from 50 to 80 nm (measured by transmission electron microscope, TEM). In addition, the study investigated the impact of gac oil content on the particle size of SLNs-gac oil and its stability under different storage conditions of UV radiation and storage temperature. At high storage temperatures, the color changes (ΔE) of the samples were more profound in comparison to that at the low storage temperature. The ΔE value of the blank sample (SLN-FREE gac-oil) was higher than that of the Gac oil-loaded SLNs samples (SLN-gac oil).

In this study, kaffir lime peel was used for extraction of essential oil by hydrodistillation and evaluation of physico-chemical characteristics. The yield of essential oil was 1.8 %. The physico-chemical parameters averaged specific gravity (0.8587g/cm3), acid index (0.667 mg KOH/g), ester index (4.203 mg KOH/g), refractive index (1.469), rotator power +3. Twenty-three components were classified in kaffir lime peel oils. The result of GC-MS revealed that the oil is extremely rich in α-pinene (35.54 %), Eucalyptol (20.902 %), camphene (4.384 %), bicyclo[3.1.1]hept-3-en-2-one (7.794 %), caryophyllene (1.225 %), endo-borneol (4.147 %), bornyl acetate (4.065%). The aim of this study is to promote for further research on extraction enhancement and application of that constituents to cosmetics, medicine and food industries to enhance antioxidant and anti-bacterial capabilities create more useful formulations

This study attempted the extraction of essential oils from the peels of pomelo (Citrus grandis L.) grown in Ben Tre province, Vietnam through hydrodistillation method. In addition, the chemical composition and physio-chemical properties of the essential oils were reported. The results showed that the extraction yield of the extraction process achieved about 1.67%. The physico-chemical index of essential oils is determined by specific gravity (0.8572 g/cm3), acid index (0.3556 mg KOH/g), ester index (2.4216 mg KOH/g), and refractive index (1.476). The GC-MS analyses of the oil indicated the component with highest content in the oil was α-limonene (96.491%), followed by α-pinene (0.686%), β-pinene (0.248%), β-myrcene (1.644%), α-phellandrene (0.793%) and β-cis-ocimene (0.138%). These results suggested that wastes from fruit peeling process can be converted into a new material source with great potential for industrial use.

Sacha inchi (Plukenetia volubilis L.) seed oil was studied for physico-chemical characteristics and chemical composition. Through gas chromatography-flame ionization (GC-FID) process, the fatty acid composition in the oil was analyzed, revealing that the oil is rich in linoleic acid (42.62 %), linolenic acid (36.32 %) and oleic acid (11.64 %). The tocopherol level in the oil was also high (7.7 ± 0.005 mg/Kg), revealed by high-performance liquid chromatography/ultraviolet-visible detector (HPLC/UV-VIS). The physico-chemical properties of the oil were also examined, including viscosity (88-92 cP), acid value (2.05 ± 0.005 mg KOH/g), saponification content (183.5 ± 1.45 mg KOH/g) and iodine value (192.4 ± 1.55 g I2/100 g). The results also indicated that sacha inchi is a health beneficial oil due to the high contents of essential fatty acids (ω-3, ω-6 and ω-9).