Purpose: In milling of stainless steel materials, various cutting tool failures such as flank wear, crater wear, cracks, chipping, etc. can be observed because of their work hardening tendency and low thermal conductivity. For this reason, this paper aims to develop some coolants and coatings to reduce these formations. However, further research should be performed to reach the desired level. Design/methodology/approach: In this study, the initial flank wear rates of uncoated and titanium nitride-coated tungsten carbide cutting tools were investigated during the milling of AISI 430 ferritic stainless steel. The milling experiments were conducted under dry and minimum quantity lubrication (MQL) conditions. Nano graphene reinforced vegetable cutting fluid was prepared and applied by the MQL system. The mixture ratios of nanofluids were selected as 1 and 2 wt.%, and MQL flow rates were adjusted at 20 and 40 ml/h. Findings: It was observed that MQL milling with nano graphene reinforced cutting fluid has advantages over dry milling and MQL milling with pure cutting fluid in terms of the initial flank wear. Originality/value: This paper contains new and significant information adequate to justify publication. MQL is a new method for vegetable cutting fluid containing nano graphene particles.
Polymer composite materials can be produced by reinforcing carbon black, carbon fiber, graphite, graphene, metals and metal oxides, nanotubes, and so on. These types of composite materials can be employed in applications demanding electrical conductivity besides high specific strength and stiffness properties of polymer materials. In the literature, there is a lack of knowledge on the examination of drilling of particle-reinforced composite materials. In this study, drilling of pure polypropylene and carbon black–reinforced polypropylene composite material was investigated at different drill point angles, cutting speeds, and feeds. The cutting temperature of drill point and surface roughness of holes were examined. The experimental studies were designed by L27 full-factorial design, and analysis of variance statistical method was performed. According to the results, cutting temperature increased and surface roughness decreased with the increase in the cutting speed and feed and decrease in the drill point angle.
28 January 2022 in Journal of Materials Engineering and Performance
Stainless steel is hard-to-cut due to its material specifications and many problems are encountered machining it. Nevertheless, stainless steel is frequently preferred in industry and its use increases. In this experimental study, the machining of AISI 430 ferritic stainless steel under dry, MQL (minimum quantity lubrication) and nanofluid MQL milling conditions was investigated. Nanofluids were prepared by adding 1 wt.-% and 2 wt.-% nano graphene to commercial vegetable cutting fluid. In these experiments, uncoated WC (tungsten carbide) and TiN (titanium nitride) coated WC cutting tools were used and MQL flow rates were selected as 20 ml × h−1 and 40 ml × h−1. Surface roughness and cutting temperatures were measured and the effects of using nanofluid, MQL flow rate, and TiN coated cutting tools were specified. According to the experimental results, the MQL method was shown to be beneficial for reducing cutting temperature and surface roughness values and the nanofluid MQL yielded minimum values. Moreover, TiN coating and an increased MQL flow rate decreased cutting temperature and surface roughness.