Solar energy has gained prominence because of the increasing global attention received by renewable energies. This shift can be attributed to advancements and innovations in solar cell technology, which include developments of various photovoltaic materials, such as thin film and tandem solar cells, in addition to silicon-based solar cells. The latter is the most widely commercialized type of solar cell because of its exceptional durability, long-term stability, and high photoconversion efficiency; consequently, the demand for Si solar cells has been consistently increasing. PV modules are designed for an operation lifespan of 25–30 years, which has led to a gradual increase in the number of end-of-life PV modules. The appropriate management of both end-of-life and prematurely failed PV modules is critical for the recovery and separation of valuable and hazardous materials. Effective methods for end-of-life PV waste management are necessary to minimize their environmental impact and facilitate transition to a more sustainable and circular economy. This paper offers a comprehensive overview of the separation processes for silicon PV modules and summarizes the attempts to design easily recyclable modules for sustainable solar module development. Based on the studies summarized in this paper, suggestions are provided for future research.

Photovoltaic (PV) installations have traditionally relied on a conventional south-facing orientation, which maximizes energy production at noon but has lower energy generation in the morning and afternoon. Vertical photovoltaic (VPV) systems have emerged as promising alternatives to address this inconsistency. Vertical photovoltaic systems can enhance energy generation by facing east in the morning and west in the afternoon. We compared the performance of n-tunnel oxide passivated contact (n-TOPCon) and p-passivated emitter and rear contact (p-PERC) cells in vertical photovoltaic systems to determine whether the optimal installation direction of bifacial vertical photovoltaics is east or west. Our findings indicated that n-TOPCon cells exhibited higher energy yields than p-PERC cells, with a difference of approximately 8%, attributed to the superior bifaciality and lower temperature coefficient of power of n-TOPCon. Additionally, the energy yield was higher for n-TOPCon modules when the front faced east, whereas the PERC modules performed better with a west-facing front. This contributes to the knowledge of the factors for energy production in vertical photovoltaic systems and the optimization of installation configurations.