Virendra Singh

Dr. Virendra Singh


Research Focus & Metrics

Academic Career Length

13Years (2014-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 July 2023 in Separations
Verified
Journal Article
Open access
PDF file
VSVirendra Singh
Virendra Singh
NPNidhi Pant
Nidhi Pant
RSRajat Kumar Sharma
Rajat Kumar Sharma
DPDiwakar Padalia
Diwakar Padalia
Pankaj S RawatPankaj S Rawat
Pankaj S Rawat
Ahmed Mohamed HassanAhmed Mohamed Hassan
Ahmed Mohamed Hassan
Heavy metal toxicity in water is a serious problem that may have harmful effects on human health and the ecosystem. Lead [Pb(II)] and cadmium [Cd(II)] are two such heavy metal ions, present in water, whose severity is well-known and well-studied. In the current research, magnetic biochar composite (MBC) is studied as an adsorbent material for the effective removal of lead and cadmium ions from water solutions. Magnetite (Fe3O4) nanoparticles and pine-needle-derived ultrasonicated magnetic biochar were used in different weight ratios to prepare APTES (3-aminopropyl triethoxysilane)-functionalized MBC (FMBC). An average crystalline size of ~10 nm for magnetite NPs was obtained via XRD analysis. The adsorption characteristics of both Pb(II) and Cd(II) ions were investigated in a batch experiment. The FTIR spectra of raw biochar, MBC, FMBC, and metal-loaded FMBC were obtained at different stages. The decrease in the intensity of the –NH2 functional group in the FTIR spectra of the residue confirmed the successful adsorption of heavy metal ions. The SEM-EDX spectra of the residue showed the uniform adsorption of Pb(II) and Cd(II) heavy metal ions onto the surface of the adsorbent. Magnetic biochar composite (MBC) was found to be a very effective adsorbent at basic pH, as a maximum of 97% instantaneous heavy metal removal was observed for both ions in synthetic water solutions. The Langmuir isotherm model predicted the monolayer adsorption and good affinity between the metal ions and adsorbent. The prepared MBC is low-cost, environmentally friendly, and it has shown good adsorption performance. Therefore, our study suggests that the magnetic biochar composite under study is an effective adsorbent for lead and cadmium metal ion removal from aqueous solutions at normal room temperature. Only a few hundred milligrams of the adsorbent dose is sufficient to remove higher concentrations (~100 ppm) of lead and cadmium at basic pH conditions of aqueous solutions.

1 May 2017 in Journal of Applied Spectroscopy
Verified
Journal Article
Closed access
PDF file
VSVirendra Singh
Virendra Singh
GJG. C. Joshi
G. C. Joshi
DBDinesh C. S. Bisht
Dinesh C. S. Bisht

14 July 2024 in Radiation Physics and Chemistry
Verified
Journal Article
Closed access
MRManish Singh Rautela
Manish Singh Rautela
VSVirendra Singh
Virendra Singh
NSNeeraj Singh
Neeraj Singh

1 December 2014 in Analytical Letters
Verified
Journal Article
Closed access
VSVirendra Singh
Virendra Singh
HAH. M. Agrawal
H. M. Agrawal
A procedure to investigate the controlling phase of aluminum solubility in soil was developed. Following pretreatment, X-ray diffraction (XRD) was used to determine the aluminum phases present in soil. Gibbsite, kaolinite, and muscovite were observed as the aluminum phases by XRD. From identification of the aluminum phases, a solubility diagram was created to investigate the phase that controls aluminum activity. The aluminum ion activity was obtained experimentally by determining the activity coefficients of hydrolysis species of aluminum, the pH, total aluminum concentration, and the fluoride activities. Soil conductivity was measured to find the ionic strength that was subsequently used to calculate the values of activity coefficients for different valence states. The results suggest that gibbsite solubility line is far away from the experimental line for the studied soil. Kaolinite was the least soluble phase by XRD but the results show it had a reduced effect upon the aluminum ion activity. If quartz was assumed to be the controlling phase and the potassium ion concentration was 1 × 10−3.6 M, the muscovite line fell close to the experimental value but deviates at higher or lower potassium ion activities.

1 April 2024 in International Journal of Materials Research
Verified
Journal Article
Closed access
BYBasant Kumar Yadav
Basant Kumar Yadav
VSVirendra Singh
Virendra Singh
RGRajat Gangwar
Rajat Gangwar
NBNeeraj Bisht
Neeraj Bisht
Erbium doped zinc boro-tellurite (EZBT) glass samples with molar composition of (55 − x)TeO2–20ZnO–25B2O3–xEr2O3 (x = 0.0, 0.5, 1.0, 1.5 and 2.0 mol.%) were prepared by a conventional melt quenching technique. The prepared samples were characterised using X-ray diffraction, Fourier transform infrared spectroscopy and ultraviolet–visible spectroscopy techniques to investigate the structural, optical and dielectric properties. To study the radiation shielding capabilities, the parameters such as mass attenuation coefficient (μ m), half-value layer (HVL), effective atomic number (Z eff) etc., were evaluated using WinXCom software. Judd–Ofelt analysis was carried out to determine the intensity of electronic transitions and other radiative transition parameters within the 4f shell of erbium ions. The μ m values in a range of (108.5–0.03) cm2 g−1 for energy range (0.01–10) MeV were obtained for 2.0 mol.% erbium-doped tellurite glass matrix. The μ m and HVL values were also compared with conventionally used ordinary concrete and specific lead borate glass at certain energies. The detailed investigation of this current EZBT glass matrix is very useful in the specific optical and radiation shielding applications of this EZBT glass.