Heavy metal toxicity in water is a serious problem that may have harmful effects on human health and the ecosystem. Lead [Pb(II)] and cadmium [Cd(II)] are two such heavy metal ions, present in water, whose severity is well-known and well-studied. In the current research, magnetic biochar composite (MBC) is studied as an adsorbent material for the effective removal of lead and cadmium ions from water solutions. Magnetite (Fe₃O₄) nanoparticles and pine-needle-derived ultrasonicated magnetic biochar were used in different weight ratios to prepare APTES (3-aminopropyl triethoxysilane)-functionalized MBC (FMBC). An average crystalline size of ~10 nm for magnetite NPs was obtained via XRD analysis. The adsorption characteristics of both Pb(II) and Cd(II) ions were investigated in a batch experiment. The FTIR spectra of raw biochar, MBC, FMBC, and metal-loaded FMBC were obtained at different stages. The decrease in the intensity of the –NH₂ functional group in the FTIR spectra of the residue confirmed the successful adsorption of heavy metal ions. The SEM-EDX spectra of the residue showed the uniform adsorption of Pb(II) and Cd(II) heavy metal ions onto the surface of the adsorbent. Magnetic biochar composite (MBC) was found to be a very effective adsorbent at basic pH, as a maximum of 97% instantaneous heavy metal removal was observed for both ions in synthetic water solutions. The Langmuir isotherm model predicted the monolayer adsorption and good affinity between the metal ions and adsorbent. The prepared MBC is low-cost, environmentally friendly, and it has shown good adsorption performance. Therefore, our study suggests that the magnetic biochar composite under study is an effective adsorbent for lead and cadmium metal ion removal from aqueous solutions at normal room temperature. Only a few hundred milligrams of the adsorbent dose is sufficient to remove higher concentrations (~100 ppm) of lead and cadmium at basic pH conditions of aqueous solutions.

In the current work, europium-doped barium titanate particles were used as filler material and polystyrene was used as a matrix to fabricate Ba_1−3x/2Eu_xTiO₃/PS polymer nanocomposites with x = 0, 0.005, 0.015 and 0.025. A solid-state reaction was used to synthesize filler particles and the solvent evaporation method was used to form polymer nanocomposites. The effects of ultrasonic treatment were also studied in the formation of nanocomposite materials. The quantitative and qualitative studies were conducted using X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), field emission scanning electron microscopy (FE-SEM), and ultraviolet-visible (UV-Vis) characterization techniques. The XRD data and FTIR data confirm the incorporation of filler particles in the polymer matrix. FE-SEM data confirms that the particles are in the nanophase. The optical band gap was directly affected by the filler particles and it started to reduce as Eu concentration started to increase.