The study was carried out to evaluate theoretically and in laboratory conditions the capacity of a hybrid heating and cooling system that sustainably uses thermal energy extracted from surface waters in order to decarbonize buildings located near water sources. The novelty of the research consists in the realization of two experimental systems, one for the rapid evaluation of the performance of the water–water heat pump heating system and one for the evaluation of the operating behavior of a cooling system with fan coil units. Starting with the heating and cooling demand, and the climatic and hydrological local characteristics, a hybrid system model for the heating and cooling of the analyzed building was established and implemented. The forecasted energy consumption and CO2 emissions for the operation of the new equipment were compared with the historical values of the old systems with which the building was equipped (thermal energy supply from the district heating and cooling system with an air conditioning unit). Also, the results were extrapolated for forecasting the energy potential of the surface waters. The study highlights a percentage reduction in annual energy consumption of 67.71% and CO2 emissions of 80.13% through the implementation of the hybrid system.
One of the important stages of energy efficiency measures for buildings is the optimal choice of heating and cooling systems, as well as that of heat/cold production sources, so as to minimize dependence on conventional fuels and the national energy system. Currently, the option for integrating renewable energy sources addressed in the building efficiency stage is the installation of solar systems. In the context of the need to reduce energy consumption and reduce pollutant emissions, and the need to integrate renewable energy sources, the article addresses the implementation of a hybrid system with a water-to-water heat pump and photovoltaic panels, capable of achieving the decarbonization of the heating/cooling of a University Politehnica Timisoara teaching/research laboratory. The analyzed hybrid system uses the thermal potential of the Bega channel as a heat/cold source, and as a source for electricity production, a PV system, supported by the national energy system. Following the analysis of the operation of the building’s hybrid system for heating and cooling, during 4 November 2024–12 September 2025, an energy independence of approximately 90.7% and a reduction in CO2 emissions of 4.17 t/year was found.
At national and international level, climate change is a major challenge, and its approach must consider radical changes in the production of energy from renewable sources. To this end, the article proposes an analysis of the impact of climatic conditions on the performance of solar photovoltaic systems. A polycrystalline photovoltaic panel (Solovent SV-L-230) was tested under various specific conditions: dust accumulation, water film, clouds / partial shading effects and solid deposits (dry leaves, grass, straw). The experimental measurements were performed at the Faculty of Constructions in Timisoara using the equipment from the LE laboratory (Electrical Laboratory) of the Specialized Building Services. The results obtained for the photovoltaic panel show that the accumulation of dust reduces the output power by 43% and the efficiency by 57.12%. From the point of view of the impact of the water film on the surface of the panel, there is an improvement in the output power of the panel at least 6.5%, and solid deposits (dry leaves, grass, straw) reduce the output power of the photovoltaic system by about 47 %.
Worldwide, the amount of waste (hazardous and non-hazardous) generated by various processes varies from year to year and the whole planet is facing severe problems regarding pollution, especially water pollution. The article aims to propose a solution to reduce the impact on the environment by separating inorganic components from technological wastewater, recovery of recyclable waste and minimizing the amount of waste destined for storage. Thereby, the article proposes the construction of a plant for the separation of inorganic components from waste that are currently destined for storage. The hydraulic separation installation by centrifugation with hydrocyclone proposed, can contribute to improving the quality of industrial waste management services and recovery of reusable waste (manufacturing waste, slurry and water).
The need to build multistory parking in congested areas of cities presents new challenges regarding the estimation of the impact of these investments on the environment and neighboring buildings. The authors synthesize the data available in the official EU documentation and in the scientific literature and propose a method for calculating polluting gaseous emissions generated in multistory car parks. For the case study targeting the MB-UPT car park, a scheme with functional blocks was created, with elements that quantitatively and qualitatively influence the polluting gaseous emissions (CO, CO2, NMVOC, NOx, NH3) generated by the operation of the car park. The study considers a fleet of motor vehicles with characteristics like those of the motor vehicles in the car park in Timiș County. The calculation method was applied considering three operating scenarios with high-level emissions, estimated to be encountered in real operation. Considering the operating modes of the motor vehicles, emission factors and correction coefficients were chosen for the highest possible degree of confidence in the emission estimates. The results are presented graphically and in tabular form. From the analysis of the results, for each pollutant species analyzed, the relevant critical factor was determined in the context of the three scenarios. The method proposed by the authors allows for the quantitative determination of polluting gaseous emissions and easy identification of episodes and zones with high emissions.