This paper examines how surveying and monitoring improve our knowledge about ancient buildings, allow the interpretation of their structural response and help in the search for the best solutions for their conservation. The case study of Palazzo del Capitano in Mantua (Italy) is analyzed. In particular, the attention is focused on the use of a Terrestrial Laser Scanner (TLS) for surveying and monitoring too, considering that the building structural control has been performed in combination with other traditional topographic techniques such as geometric leveling and topographic networks for 3D control based on measurements through total stations. The study of TLS monitoring has been tested only in the last decade and it is an innovative method for the detection of displacements of particular surfaces. Till now the research has focused only on the use of TLS monitoring to control large structures and in particular landscape situations; thus its use for a civil construction and historical buildings is a new field of investigation. Despite the fact technological development and new methodologies seem offer new future potential for the analysis of ancient buildings, currently there are still important limits for the application of the investigated surveying and monitoring techniques.
1 February 2018 in Construction and Building Materials
Various carbon fiber–reinforced polymer (CFRP) strengthening systems have been developed to increase the fatigue lifetime of existing aging steel structures. According to the literature, the results of fatigue tests on CFRP-strengthened steel plates showed a significant increase in the fatigue lifetime of the specimens, compared with the bare ones. In particular, the fatigue lifetime extension was more pronounced for short initial crack sizes (i.e., low initial damage level). In this study, the fatigue-crack growth curves in bonded CFRP-strengthened single edge notched tension (SENT) specimens were numerically investigated. The proposed numerical approach adopted a cyclic cohesive-zone model (CCZM), which enabled the simulation of crack growth in steel plates, through the definition of a scalar damage variable (k). The selected model contained some parameters that did not possess a precise physical meaning and therefore were not amenable to direct measurement. Therefore, a robust identification procedure was proposed to calibrate the model parameters that governed fatigue behavior, which was based on the response of unstrengthened specimens in the crack propagation curves. The successful identification was then validated by comparison with the measured response of the strengthened SENT specimens, which were modeled by adopting the same identified model parameters. The adhesive between the CFRP laminate and steel substrate was simulated by defining an elasto–brittle surface-to-surface contact model, whose properties were selected based on well known approaches that were proposed in the literature.