We present quantitative measurements of the interaction between a guided optical wave and a two-dimensional photonic crystal using spontaneous emission of the material as an internal point source. This is the first analysis at near-infrared wavelengths where transmission, reflection, and in-plane diffraction are quantified at the same time. Low transmission coincides with high reflection or in-plane diffraction, indicating that the light remains guided upon interaction. Also, good qualitative agreement is found with a two-dimensional simulation based on the transfer matrix method.

The authors report the observation of a cavity mode, at λ = 0.94 µm, which is tightly confined between two slabs of two-dimensional photonic crystals deeply etched into a laser-like heterostructure waveguide. Guided photoluminescence of this heterostructure is used as an internal point source to probe the horizontal cavity.

Optical feedback interferometry (OFI) performance for microscale-flow sensing is studied theoretically and experimentally. A new numerical modeling approach for OFI flow meter spectrum reproduction is presented in this work to study the optical effect on the signal due to the micro-scale channel geometry. Two well-defined frequency peaks are found in the OFI spectrum, this phenomenon can be attributed to the reflection of the forward scattered light on the channel rear interface. The flow rate measurement shows good accuracy over a range of fluid velocities from 16.8 mm/s to 168 mm/s, thus providing a promising tool to study and to optimize the OFI microfluidic sensor system.

We present a quantitative study on the fabrication of microlenses using a low-cost polymer dispending technique. Our method is based on the use of a silicon micro-cantilever robotized spotter system. We first give a detailed description of the technique. In a second part, the fabricated microlenses are fully characterized by means of SEM (Scanning Electron Microscope), AFM (Atomic Force Microscopy) non contact optical profilometry and Mach-Zehnder interferometry. Diameters in the range [25–130μm] are obtained with an average surface roughness of 2.02nm. Curvature radii, focal lengths as well as aberrations are also measured for the first time: the fabricated microlenses present focal lengths in the range [55–181μm] and exhibit high optical quality only limited by diffraction behaviour with RMS aberration lower than λ/14.