The introduction of long-chain branched structures into biodegradable polyesters can effectively improve the melt strength and blow-molding properties of polyesters. In this study, pentaerythritol (PER) was used as a branching agent to synthesize branched poly(butylene dodecanedioate) (PBD), and the resulting polymers were characterized by Nuclear Magnetic Resonance Proton Spectra (1H NMR) and Fourier Transform Infrared spectroscopy (FT-IR). It was found that the introduction of a small amount of PER (0.25–0.5 mol%) can generate branching and even crosslinking structures. Both impact strength and tensile modulus can be greatly improved by the introduction of a branching agent. With the introduction of 1 mol% PER content in PBD, the notched impact strength of PBD has been increased by 85%, and the tensile modulus has been increased by 206%. Wide-angle X-ray diffraction and differential scanning calorimetry results showed that PER-branched PBDs exhibited improved crystallization ability compared with linear PBDs. Dynamic viscoelastics revealed that shear-thickening behaviors can be found for all branched PBD under low shear rates.
A polyamine water treatment agent was prepared with the film-forming amine (N-oleyl-1,3-propylenediamine) and the neutralizing amine (cyclohexanamine) under optimal conditions. The copper sulfate liquid drop experiment showed that a protective film was formed by the polyamine water treatment agent on carbon steel. The analyses of the polarization curve and electrochemical impedance spectroscopy of carbon steel indicated that the polyamine water treatment agent exhibited geometric effects, which could inhibit both anode and cathode reactions of carbon steel, and the corrosion inhibition effect of the polyamine water treatment agent showed an extreme-concentration phenomenon. A metal corrosion experiment in a simulated boiler steam–water system indicated that the polyamine water treatment agent mitigated the corrosion of carbon steel at different temperatures, and the corrosion inhibition rates of the polyamine water treatment agent in liquid and gas environments at 150 °C were 53.84% and 67.43%, respectively, better than that at 350 °C. SEM-EDS characterization indicated that the formation of the corrosion product, iron oxide, on the carbon steel was reduced with the addition of the polyamine water treatment agent in the simulated boiler steam–water system.
Severe erosion phenomena often occur in industrial polycrystalline silicon units, leading to hydrogen leakage accidents and affecting long-term operation. It is favorable to use a computational fluid dynamics (CFD) simulation with the dense discrete phase model (DDPM) and the sub-grid energy-minimization multi-scale (EMMS) drag model to improve the prediction accuracy of complex multiphase erosion phenomena in a connecting pipe of an industrial polycrystalline silicon unit. Furthermore, the effect of droplet the specularity coefficient on boundary conditions is thoroughly considered. The predicted erosion behaviors are consistent with industrial data. The effects of operations parameters were discussed with three-dimensional CFD simulation, including droplet size and hydrogen volume fraction on erosion behaviors. The results indicated that the non-uniform multiphase erosion flow behavior near the wall can be simulated accurately with the EMMS drag model in a coarse mesh. A suitable droplet specularity coefficient such as 0.5 can also improve the accuracy of erosion position. Small liquid droplets, such as those of 30 μm size, will follow the gas phase better and have a lower erosion rate. The inertia effect of large droplets, such as those of 150 μm size, plays a dominant role, resulting in obvious erosion on the elbow walls. The erosion range and thinning rate enlarge with the increase in hydrogen volume fraction. A few silicon solid particles, such as 0.01% volume fraction, change local flow behaviors and probably cause the variation of local erosion positions. The process of erosion deformation first circumferentially extended and then accelerated at the local center position deeper.
5 November 2024 in Chemical Engineering and Processing - Process Intensification