A polyamine water treatment agent was prepared with the film-forming amine (N-oleyl-1,3-propylenediamine) and the neutralizing amine (cyclohexanamine) under optimal conditions. The copper sulfate liquid drop experiment showed that a protective film was formed by the polyamine water treatment agent on carbon steel. The analyses of the polarization curve and electrochemical impedance spectroscopy of carbon steel indicated that the polyamine water treatment agent exhibited geometric effects, which could inhibit both anode and cathode reactions of carbon steel, and the corrosion inhibition effect of the polyamine water treatment agent showed an extreme-concentration phenomenon. A metal corrosion experiment in a simulated boiler steam–water system indicated that the polyamine water treatment agent mitigated the corrosion of carbon steel at different temperatures, and the corrosion inhibition rates of the polyamine water treatment agent in liquid and gas environments at 150 °C were 53.84% and 67.43%, respectively, better than that at 350 °C. SEM-EDS characterization indicated that the formation of the corrosion product, iron oxide, on the carbon steel was reduced with the addition of the polyamine water treatment agent in the simulated boiler steam–water system.
Brine with a high magnesium-to-lithium ratio was separated by electrodialysis equipped with a monovalent cation exchange membrane under differing operational parameters. The ionic concentration variations, separation coefficients, lithium recovery ratio, permselectivity coefficient, and Li+ flux were analyzed to evaluate the effect of the initial Li+/Mg2+ mass concentration ratio, applied voltage, and initial volume ratio between the dilute and concentrated compartments on the separation performance of magnesium and lithium. The results showed that the increase in initial Li+/Mg2+ concentration ratio significantly increased the separation coefficient, lithium recovery ratio, and Li+ flux, demonstrating an improvement in the separation performance since the Li+ migration was accelerated when less Mg2+ competed with Li+. As the applied voltage increased from 10 V to 15 V, the separation coefficient increased, and the lithium recovery ratio and Li+ flux increased within 60 min; however, as the applied voltage increased to 20 V, the separation coefficient, the lithium recovery ratio, and the Li+ flux did not increase, which indicated that an increase in the applied voltage within the limits would contribute to the separation performance. The increase in the initial volume ratio between the dilute and concentrated compartments decreased the separation coefficient and lithium recovery ratio, indicating that the separation performance had declined.
Hydrogenation reactors are critical equipment in the petrochemical industry, yet their material degradation is governed by coupled multi-mechanism damage. Current assessment practices largely neglect this complexity, remaining single-factor oriented and overlooking synergistic interactions and temporal evolution. This paper proposes a regionally differentiated, multi-level framework integrating 5 primary and 17 secondary indicators with a hybrid AHP-EWM weighting strategy that synthesizes expert knowledge and measured data. A multi-factor coupling correction coefficient is introduced to provide a preliminary estimate of the synergistic acceleration effect among damage mechanisms, while a GM(1,1) gray model enables dynamic trend prediction. Applied to a 25-year 2.25Cr-1Mo steel reactor, the method produces regional degradation values of 0.378, 0.607, and 0.533 for the base metal, welds, and cladding layer, respectively, with an overall baseline of 0.453 rising by 11% to 0.503 after coupling correction. Compared with exponential regression, ARIMA, and BP neural networks, GM(1,1) is selected for its balanced performance in small-sample fitting, extrapolation stability, and physical interpretability. Sensitivity analysis confirms stable degradation grading even with ±50% coupling coefficient variations. The proposed approach mitigates the underestimation inherent in conventional single-mechanism assessments and offers a quantitative tool for full-lifecycle risk management and predictive maintenance of hydrogenation reactors.