For space-based gravitational wave detection, a laser interferometric measurement system composed of a three-spacecraft formation offers the most rewarding bandwidth of astrophysical sources. There are no oscillators available that are stable enough so that each spacecraft could use its own reference frequency. The conversion between reference frequencies and their distribution between all spacecrafts for the synchronization of the different metrology systems is the job of the inter-spacecraft frequency setting strategy, which is important for continuously acquiring scientific data and suppressing measurement noise. We propose a hierarchical optimization algorithm to solve the frequency setting strategy. The optimization objectives are minimum total readout displacement noise and maximum beat-note frequency feasible range. Multiple feasible parameter combinations were obtained for the Taiji program. These optimized parameters include lower and upper bounds of the beat note, sampling frequency, pilot tone signal frequency, ultrastable clock frequencies, and modulation depth. Among the 20 Pareto optimal solutions, the minimum total readout displacement noise was 4.12 , and the maximum feasible beat-note frequency range was 23 MHz. By adjusting the upper bound of beat-note frequency and laser power transmitted by the telescope, we explored the effects of these parameters on the minimum total readout displacement noise and optimal local laser power in greater depth. Our results may serve as a reference for the optimal design of laser interferometry system instrument parameters and may ultimately improve the detection performance and continuous detection time of the Taiji program.
HPHangzhou 310024 Key Laboratory Of Gravitational Wave Precision Measurement Of Zhejiang Province
Hangzhou 310024 Key Laboratory Of Gravitational Wave Precision Measurement Of Zhejiang Province
+4
The predecessor of China Optics was China Optics and Applied Optics Digest, which was founded in 1985. At that time, it was the only retrieval journal in the field of optics in China. At the end of 2008, China Optics and Applied Optics Digest was renamed 《中国光学》的前身是1985年创办的《中国光学与应用光学文摘》,当时是国内光学领域唯一的检索刊物。2008年底《中国光学与应用光学文摘》转型更名为《中国光学与应用光学》期刊,刊载内容突破了文摘的限制,正式成为学术刊物。
High-temperature two-dimensional digital image correlation (2D-DIC) can produce spatially unstable strain fields and biased condition-averaged incremental strains, but these error signatures need not respond to the same processing. A smoother strain field is therefore not, by itself, evidence of improved scalar accuracy. We evaluated strain field visualization stability separately from extensometer-referenced, condition-level incremental strain accuracy. An MA956 specimen was tested at 600, 700 and 800 °C under 12 loading conditions spanning 500–2000 µε, with four manually triggered snapshots acquired per condition. The field path used affine registration, pixelwise four-snapshot median fusion and strain radius sensitivity analysis. The scalar path used only the original unfused images and compared four prespecified models under leave-one-temperature-out internal assessment. Increasing the strain radius from 10 to 15 grid points reduced the spatial standard deviation and P95-to-median span by 22.7% and 16.6%, respectively, with little change in scalar RMSE. Controlled simulations with known ground truth showed that local non-affine disturbances primarily increased field dispersion, whereas isotropic scale changes induced approximately common-mode axial and transverse strain drift. Across 20 mechanical strain–magnification conditions, a common-mode-suppressed axial–transverse feature reduced RMSE from 439.7 to 49.8 µε. Guided by this mechanistic evidence, combining the feature with temperature terms yielded the lowest pooled out-of-fold RMSE of 76.27 µε in the experimental data, 69.7% below the raw axial strain baseline. Within the conditions examined, these results demonstrate that improved strain field visualization is insufficient evidence of scalar accuracy and support separate validation of field stability and condition-level incremental strain error.