In order to study the thermoelectric properties of individual nanowires, a thermoelectric nanowire characterization platform (TNCP) has been previously developed and used in our chair. Here, we report on a redesigned platform aiming to optimize performance, mechanical stability and usability. We compare both platforms for electrical conductivity and the Seebeck coefficient for an individual Ag nanowire of the previously-used batch and for comparable measurement conditions. By this, the measurement performance of both designs can be investigated. As a result, whereas the electrical conductivity is comparable, the Seebeck coefficient shows a 50% deviation with respect to the previous studies. We discuss the possible effects of the platform design on the thermoelectric measurements. One reason for the deviation of the Seebeck coefficient is the design of the platform leading to temperature gradients along the bond pads. We further analyze the effect of bonding materials Au and Pt, as well as the effect of temperature distributions along the bond pads used for the thermovoltage acquisition. Another major reason for the variation of the measurement results is the non-homogeneous temperature distribution along the thermometer. We conclude that for the measurement of small Seebeck coefficients, an isothermal positioning of voltage-probing bond pads, as well as a constant temperature profile at the measurement zone are essential.
1 October 2016 in Journal of Physics: Conference Series
We report on the fabrication of a silicon platform for the thermoelectric and structural characterization of single nanowires, equipped with nanoporous electrodes. Controlled wafer thinning to a thickness of 160 μm results in platform chips, which can be inserted into Transmission Electron Microscopes (TEM) for the nanowire's structural composition analysis. Our fabrication approach comprises the Bosch process (ICP), and "dicing before grinding" techniques to achieve this small thickness. To study the idea of developing a "plug-and-measure" platform, we have developed a novel approach for selfadhesion between a contact electrode and a nanowire by nanoporous electrodes. Due to the increased surface-to-volume ratio and increased van-der-Walls forces nanowires stick firmly to the electrodes for a good thermal and electrical connection. This innovative technique does also avoids, in best case, separate steps for contact formation.
15 January 2018 in IEEE Transactions on Semiconductor Manufacturing
A nanowire characterization platform is designed and fabricated in MEMS-technology for the thermoelectric and structural characterization of single nanowires. The latter is achieved by making the chip compatible to TEM holder, by restricting its thickness to less than 160 μm and its diagonal dimensions to less than 3 mm. Two different fabrication technologies are presented for the realization of such platform, based on a design reproducing the functional requirements. Our first fabrication technique is based on ICP etching, using (100)-silicon wafers, and a subsequent rear grinding. However, as the design includes a vertical wall trench structures, ICP etching of such deep recesses is time-consuming and expensive. Therefore, a second fabrication process is developed, making use of wet-etched (110)-silicon. With these substrates a challenge arises from the intersection of inclined {111} facets. To solve this natural limitation, we introduce a novel fabrication process. Our technique relies on damaging the intersecting {111} planes, to make them etchable again and to produce deeper trenches with vertical walls in a wet-chemical etching process. Additionally, the electrical contacts at the platform are made from porous metal to increase the surface-to-volume ratio, to increase the possibility of a spontaneous electrical contact between the electrodes and nanowires.