The influence of size effects on the thermoelectric properties of thin platinum films is investigated and compared to the bulk. Structural properties, like the film thickness and the grain size, are varied. We correlate the electron mean free path with the temperature dependence of the electrical conductivity and the absolute Seebeck coefficient of platinum. A measurement platform was developed as a standardized method to determine and show that is reduced compared to . Boundary and surface scattering reduce the thermodiffusion and the phonon drag contribution to by nearly the same factor. We discuss in detail on behalf of a model, which describes the temperature dependence of the absolute Seebeck coefficient, the influence of size effects of electron-phonon and phonon-phonon interaction on .
Thermoelectric phenomena can be strongly modified in nanomaterials. The determination of the absolute Seebeck coefficient is a major challenge for metrology with respect to micro- and nanostructures due to the fact that the transport properties of the bulk material are no more valid. Here, we demonstrate a method to determine the absolute Seebeck coefficient S of individual metallic nanowires. For highly pure and single crystalline silver nanowires, we show the influence of nanopatterning on S in the temperature range between 16 K and 300 K. At room temperature, a nanowire diameter below 200 nm suppresses S by 50% compared to the bulk material to less than S = 1 μVK−1, which is attributed to the reduced electron mean free path. The temperature dependence of the absolute Seebeck coefficient depends on size effects. Thermodiffusion and phonon drag are reduced with respect to the bulk material and the ratio of electron-phonon to phonon-phonon interaction is significantly increased.
We demonstrate the full thermoelectric and structural characterization of individual bismuth-based (Bi-based) core/shell nanowires. The influence of strain on the temperature dependence of the electrical conductivity, the absolute Seebeck coefficient and the thermal conductivity of bismuth/titanium dioxide (Bi/TiO2) nanowires with different diameters is investigated and compared to bismuth (Bi) and bismuth/tellurium (Bi/Te) nanowires and bismuth bulk. Scattering at surfaces, crystal defects and interfaces between the core and the shell reduces the electrical conductivity to less than 5% and the thermal conductivity to less than 25% to 50% of the bulk value at room temperature. On behalf of a compressive strain, Bi/TiO2 core/shell nanowires show a decreasing electrical conductivity with decreasing temperature opposed to that of Bi and Bi/Te nanowires. We find that the compressive strain induced by the TiO2 shell can lead to a band opening of bismuth increasing the absolute Seebeck coefficient by 10% to 30% compared to bulk at room temperature. In the semiconducting state, the activation energy is determined to |41.3 ± 0.2| meV. We show that if the strain exceeds the elastic limit the semimetallic state is recovered due to the lattice relaxation.
In order to study the thermoelectric properties of individual nanowires, a thermoelectric nanowire characterization platform (TNCP) has been previously developed and used in our chair. Here, we report on a redesigned platform aiming to optimize performance, mechanical stability and usability. We compare both platforms for electrical conductivity and the Seebeck coefficient for an individual Ag nanowire of the previously-used batch and for comparable measurement conditions. By this, the measurement performance of both designs can be investigated. As a result, whereas the electrical conductivity is comparable, the Seebeck coefficient shows a 50% deviation with respect to the previous studies. We discuss the possible effects of the platform design on the thermoelectric measurements. One reason for the deviation of the Seebeck coefficient is the design of the platform leading to temperature gradients along the bond pads. We further analyze the effect of bonding materials Au and Pt, as well as the effect of temperature distributions along the bond pads used for the thermovoltage acquisition. Another major reason for the variation of the measurement results is the non-homogeneous temperature distribution along the thermometer. We conclude that for the measurement of small Seebeck coefficients, an isothermal positioning of voltage-probing bond pads, as well as a constant temperature profile at the measurement zone are essential.
We report on the functionality of our Thermoelectric Nanowire Characterization Platform (TNCP). As a proof of concept of our design, we present a set of experimental results obtained from the characterization of a single Bi2Te3 nanowire, allowing for the determination of the nanowire’s electrical conductivity and Seebeck coefficient.
The influence of size effects on the thermoelectric properties of thin platinum films is investigated and compared to the bulk. Structural properties, like the film thickness and the grain size, are varied. We correlate the electron mean free path with the temperature dependence of the electrical conductivity and the absolute Seebeck coefficient $S_{\text{Pt}}$ of platinum. We use a measurement platform as a standardized method to determine $S_{\text{Pt}}$ and show that $S_{\text{Pt,film}}$ is reduced compared to $S_{\text{Pt,bulk}}$. Boundary and surface scattering reduce the thermodiffusion and the phonon drag contribution to $S_{\text{Pt,film}}$ by nearly the same factor. A detailed discussion and a model to describe the temperature dependence of the absolute Seebeck coefficient and the influence of size effects of electron-phonon and phonon-phonon interaction on $S_{\text{Pt}}$ is given.