In this study, an experimental apparatus was used to produce dried shrimp. From experiments with various air velocities and temperatures, the drying constant, moisture transfer coefficient and moisture diffusivity were obtained by using a Bi-Di correlation. An equation for determining the drying constant was established to determine the drying parameters for different drying conditions. To obtain the targeted moisture, i.e., a moisture content of 0.25 (dry basis, d.b.), drying with the highest temperature and air velocity (60 °C, 2 m/s) took 3.6 h, while the lowest temperature and air velocity (50 °C, 1 m/s) required up to 5.8 h. The transport parameters were then used to simulate the temperature and moisture content distribution inside the shrimp using ANSYS software for a certain drying condition. The results showed that the shrimp temperature increased rapidly, reaching the dry air temperature after approximately 15 min. The moisture content in the tail was markedly lower than that at the centre, which is the thickest part of the shrimp. The data from this study can be used to optimize the energy consumption in shrimp convective drying technologies.
2 July 2019 in Journal of Mechanical Science and Technology
Additive alignment in polymer composites can enhance the physical properties of the constitutive material. Researchers have attempted to understand and predict the additive orientation during the fabrication process, such as injection molding. In this study, the rotation of carbon fibers embedded in uncured polydimethylsiloxane flowing in an orifice channel is analyzed via a flow visualization experiment and image processing of obtained images. The angular velocity of additives is correlated with the shear rates in the flow field calculated from the computational fluid dynamics simulation with the assumption of a single-phase and a non-Newtonian flow. The effective shear rate is found to have a larger effect on the rotation of fiber compared with the aspect ratio of the fiber and the initial alignment angle to the flow direction. A correlation between the effective shear rate and angular velocity of the fibers is developed and verified experimentally. This correlation can be used to predict the fiber rotation during polymer composite fabrication within an orifice channel and hence provide useful information regarding the anisotropic physical properties of the final product.
The objective of this study is to improve the exit flow uniformity of a gas torch with multiple exit holes for effective heating of a steel plate. The torch was simulated, and combustion experiments were performed for validation. Based on a basic model, three different revised models were designed and analyzed with the software ANSYS FLUENT 18.2. The flow uniformity (γ) of the velocity distribution at the multiple exit holes was investigated with the pressure drop ranging from 100 to 500 Pa. The basic model had flow uniformity ranging from 0.849 to 0.852, but the three new models had γ1 = 0.901–0.912, γ2 = 0.902–0.911, and γ3 = 0.901–0.914, respectively. The maximum percentage difference of the flow uniformity index between the three new models and the basic model was 7.3%. The basic model with nonuniform flow distribution made a temperature difference of the back side of the steel plate from the center to the edge of around 229 °C, while the modified model with uniform flow distribution had a smaller temperature difference of 90 °C. The simulation results showed good agreement with our experimental results for both the basic model and the modified model. The modified gas torch made a wider and more uniform temperature distribution on a preheated steel plate than the basic one. The results revealed that a trade-off between cost and flow uniformity, as well as the new gas torch, could be applied to a steel-plate preheating process before welding.