Solution-processed organic–inorganic hybrid perovskite solar cells are among the candidates to replace the traditional silicon solar cells due to their excellent power conversion efficiency (PCE). Despite this considerable progress, understanding the properties of the perovskite precursor solution is critical for perovskite solar cells (PSCs) to achieve high performance and reproducibility. However, the exploration of perovskite precursor chemistry and its effects on photovoltaic performances has been limited thus far. Herein, we modified the equilibrium of chemical species inside the precursor solution using different photoenergy and heat pathways to identify the corresponding perovskite film formation. The illuminated perovskite precursors exhibited a higher density of high-valent iodoplumbate species, resulting in the fabricated perovskite films with reduced defect density and uniform distribution. Conclusively, the perovskite solar cells prepared by the photoaged precursor solution had not only improved PCE but also enhanced current density, confirmed by device performance, conductive atomic force microscopy (C-AFM), and external quantum efficiency (EQE). This innovative precursor photoexcitation is a simple and effective physical process for boosting perovskite morphology and current density.
It is known that natural rubber is an elastomeric polymer; hence, the main uses are usually limited to soft applications. For the process to reverse the elastomeric effect of natural rubber to obtain rigid plastic from a natural material, an ultra-high amount of magnesium carbonate particles was added to the natural rubber to study the effect of magnesium carbonate in the reduction of elastomeric properties. High magnesium carbonate ratios of 80–180 phr were mixed in the natural rubber in the latex form to maximize the mixing capability since it was more difficult to achieve these mixture ratios with only two roll mill or extruder processes. The more magnesium carbonate powders in the composite, the higher torques were measured from the moving die rheometer (MDR) test. The powder was thoroughly mixed inside the composite, which was observed from energy-dispersive X-ray spectrometer (EDX) mapping; however, the matrix of composites was filled with porosity due to the CO2 formation when latex with magnesium carbonate was assimilated with acid during the vulcanization process. The strength of the composite dropped, and the elongations were shortened. On the other hand, the hardness of composites was drastically increased. The composite lost the elastomeric property, and the hard natural rubber composites were obtained.
Printable planar carbon electrodes present a cost‐effective and highly promising alternative to thermally evaporated metals, serving as the rear contact for stable perovskite solar cells (PSCs). However, the power conversion efficiencies (PCEs) of the carbon‐based PSCs (C‐PSCs) are notably lower compared to those of state‐of‐the‐art PSCs. The inferior contact between the carbon electrode and the underlying layer contributes to the performance loss. Here, we developed scalable doctor‐bladed carbon electrode by simultaneously incorporating 4 wt% carbon black and utilizing toluene (TLE) solvent engineering to a commercial carbon paste, resulting in improved flexibility and conductivity while yielding reduction of resistivity by 50% measured via a 4‐point probe. Consequently, the carbon sheet can efficiently adhere the underlying hole‐transporting layer by a simple pressing technique, significantly boosting charge transfer across the interface. The TLE device achieves a champion PCE of 15.77% with an ultralow hysteresis index (HI) of 0.027, compared to the solvent‐free device which has a HI of 0.176. The developed carbon‐based device exhibits notably improved long‐term stability when subjected to dark conditions and 40‐50% RH, sustaining 82% of its initial efficiency after 24 days without encapsulation with minimal declines in Jsc and Voc .