The quality of continuously cast slabs largely depends on the processes taking place in the mold. In continuous casting of copper and its alloys the solidification process is almost completed within it. This paper presents a comprehensive optimization of the submerged entry nozzle design by combining physical and mathematical modeling with further comparison of obtained results with the actual process. The article studies the critical features of hydrodynamic processes in copper slab by physical and mathematical modeling during continuous casting. To ensure the efficiency of liquid pool homogenization, it seems appropriate to direct some metal upwards through openings in the SEN to the liquid meniscus. The optimal configuration of the SEN is the one where 35% of the liquid flows upwards to heat the melt meniscus and slab upper corner zones and 65% of liquid metal moves downward to the liquid pool bottom.
The article presents the results of comprehensive studies of hydrodynamic processes and features of single-strand tundish ladles, which can be used for continuous or semicontinuous casting of steel at small metallurgical plants. The results of physical and mathematical modelling of the movement of the melt flows in the tundish using various designs of metal receivers are shown in this article. In addition to this, the article shows how the presence of a stagnant zone between the metal receiver and the right narrow wall of the Tundish increases in time of metal flow into the dispenser zone by an average of 35–60%. It has been established that the position and height of the walls of the metal receiver relative to the axis of the incident jet are very significant for providing a rational picture of the movement of convective flows. When the height of the wall of the metal receiver (from the side of the dispenser) is reduced by 40–60 mm, the zones of increased turbulence may appear in the liquid bath of the tundish in the areas between the metal receiver and the dispenser. The results of evaluating the efficiency of floating non-metallic inclusions in the tundish volume and optimizing the hydrodynamic pattern flows in the central part of the tundish to increase the refining effect by installing a special recess.
Introduction. The multifunctional magnetodynamic tundish prototype is the first world magnetodynamic mixer and batcher for steel, which has a capacity of up to 10 tons of melt and an inductor electric power of 600 kW. It has been successfully introduced into industry. Further works aim at adapting this device to continuous casting, in particular at obtaining semi-continuous cast billets at metallurgical micro-plants. Problem Statement. Today, the study of the effect of electromagnetic field on melt stirring and removal of non-metallics in the inlet chamber of MD-T is an urgent task. Purpose. The purpose of this research is to substantiate and to create MD-T as a two-chamber aggregate additionally equipped with a few electromagnetic & MHD devices for different purposes, to be used at metallurgical micro-mills. Materials and Methods. Physical modelling has been applied for studying liquid metal stirring under the action of electromagnetic field and the removal of non-metallics. Results. The behavior of the liquid jet falling from the ladle into the centrifugal chamber has been studied. The influence of the rational liquid level in the centrifugal chamber, which is exposed to the direct action of the electromagnetic field, has been estimated. It has been established that the effect of rotation of the total liquid volume has been achieved at the height of application of electromagnetic field, which is 0.2-03 of the total fill height. Increasing the height of the application of a magnetic field leads to the capture of the upper layers of the liquid. Conclusions. There have been proposed a new design of magnetodynamic tundish (MD-T) for continuous casting of steel. The use of tundish with a rotational motion of the flow may significantly reduce the number of large oxide inclusions (larger than 10 mu m) in steel. The device has been successfully tested and its application will improve the quality of cast billets, extend the functionality of equipment and technologies, and enable the realization of modern high-efficiency processes of continuous casting.