The influence of NBR Shore hardness and PTFE elastic modulus on the sealing characteristics of step rod seals is analyzed in this paper based on the developed mixed elastohydrodynamic lubrication (EHL) model. The optimized selection studies of NBR Shore hardness and PTFE elastic modulus under different operating conditions are carried out based on the principle of minimizing net leakage and friction power loss. Results show that the Shore hardness of the NBR O-ring and, in particular, the elastic modulus of the PTFE ring has a significant effect on the sealing characteristics. Although the high values of these parameters result in high friction forces, they are beneficial for leakage control. To achieve both low leakage and low friction, it is recommended that high hardness and low modulus are selected for moderate-low pressure or high speed conditions, but low hardness and high modulus are selected for high pressure or low speed conditions.
Thermoelastohydrodynamic (TEHD) mixed lubrication characteristics of a step-combined rod seal under high-pressure and high-speed conditions are analyzed in this article. A novel TEHD mixed lubrication model for combined rod seals is innovatively established from the perspective of “seal-film-rod” system for the first time. Parameterized studies are conducted to evaluate the thermal effect on seal behavior with the comparison of isothermal elastohydrodynamic (EHD) lubrication analysis. Numerical results show that the interface friction heat is quite remarkable and mainly concentrated on the sealing lip, especially in high pressure and speed cases. With the increasing sealed pressure or rod speed, the temperature rise becomes more obvious and has a more significant impact on the sealing performance. The excessively rising temperature will even exceed the melting point of the sealing material, causing thermal damage.
The hydraulically controllable reciprocating seal (HCRS) is a novel intelligent sealing technology capable of online performance regulation, making it one of the preferred solutions for highly reliable seals in the industrial field. However, the impact of structural parameters on the performance of it remains unclear, complicating efforts to provide precise guidance for structural design. To address these issues, this article first employs a mixed thermoelastohydrodynamic lubrication (TEHL) model to perform a parametric analysis of how structural parameters affect the static and dynamic performance of seals, identifying key influencing factors. Second, a multiobjective optimization model was established to derive the optimal structural design using a comprehensive balance method. Finally, the performance results before and after optimization were compared. The results indicate that the width of the slide ring, the air side angle of the slide ring, the inner diameter of the slide ring, and the length of the internal pressure cavity are critical factors influencing sealing performance. Following optimization, the maximum von Mises stress in the seal was reduced by 51.5%, net leakage decreased by 12.9%, and friction power loss reduced by 2.25%. This demonstrates that the optimization method is effective for designing seals with low leakage, low friction, and high reliability.
The primary function of rod seals in hydraulic systems is to prevent the leakage of the hydraulic medium, which would otherwise result in environmental pollution and the loss of energy. However, the leakage control performance of conventional rod seals is limited by the level of product design. As a result, the performance of these seals will gradually degrade during the service process. Furthermore, it is not possible to adaptively adjust the performance of these seals in response to changes in operating conditions. Hydraulically controllable rod seals (HCRS) can be driven hydraulically to adjust the internal stress distribution of the seal to regulate the sealing performance. This may be an effective solution, although the leakage control mechanism and strategy remain unclear. This paper employs a thermoelastohydrodynamic mixed lubrication model to comparatively analyze the behaviors and performances of the HCRS with or without a cavity structure. The leakage control mechanism of the HCRS is revealed, namely that it is achieved by increasing the interface contact pressure and reducing the fluid film thickness through external pressurization. Furthermore, the functional relationship between the sealing performance and the regulating variables under different operating conditions is obtained through multivariate regression analysis, thereby forming the quantitative leakage control strategy of the HCRS.