The nitrile butadiene rubber (NBR) hardness effect on the sealing characteristics of hydraulic O-ring rod seals is analyzed based on a mixed lubrication el
12 November 2018 in Journal of Zhejiang University-SCIENCE A
Thermoelastohydrodynamic (TEHD) mixed lubrication characteristics of a step-combined rod seal under high-pressure and high-speed conditions are analyzed in this article. A novel TEHD mixed lubrication model for combined rod seals is innovatively established from the perspective of “seal-film-rod” system for the first time. Parameterized studies are conducted to evaluate the thermal effect on seal behavior with the comparison of isothermal elastohydrodynamic (EHD) lubrication analysis. Numerical results show that the interface friction heat is quite remarkable and mainly concentrated on the sealing lip, especially in high pressure and speed cases. With the increasing sealed pressure or rod speed, the temperature rise becomes more obvious and has a more significant impact on the sealing performance. The excessively rising temperature will even exceed the melting point of the sealing material, causing thermal damage.
The influence of NBR Shore hardness and PTFE elastic modulus on the sealing characteristics of step rod seals is analyzed in this paper based on the developed mixed elastohydrodynamic lubrication (EHL) model. The optimized selection studies of NBR Shore hardness and PTFE elastic modulus under different operating conditions are carried out based on the principle of minimizing net leakage and friction power loss. Results show that the Shore hardness of the NBR O-ring and, in particular, the elastic modulus of the PTFE ring has a significant effect on the sealing characteristics. Although the high values of these parameters result in high friction forces, they are beneficial for leakage control. To achieve both low leakage and low friction, it is recommended that high hardness and low modulus are selected for moderate-low pressure or high speed conditions, but low hardness and high modulus are selected for high pressure or low speed conditions.
This study systematically explored the characteristics of explosion and pressure fluctuations of ethyl acetate (EA)/hydrogen (H2)/air mixtures under different initial pressures (1–3 bar), H2 fractions (4%, 8%, 12%), and equivalence ratios of EA (0.5–1.4). The flame images indicated that a higher pressure, a higher H2 fraction, and a higher equivalence ratio could cause flame instability. An analysis of the dimensionless growth rate indicated that the flame instability was impacted by both thermal diffusion and hydrodynamic effects. The results also indicated that a higher initial pressure or H2 fraction could accelerate the combustion reaction and increase the explosion pressure and deflagration index. The maximum values were observed at 21.841 bar and 184.153 bar·m/s. However, their effects on explosion duration and heat release characteristics differed between lean and rich mixtures. Additionally, this study examined pressure fluctuations in both the time and frequency domains. The findings indicated a strong correlation between pressure fluctuation and flame instability. Modifying the H2 fraction and equivalence ratio to enhance flame stability proved effective in reducing pressure fluctuation amplitude. This study offers guidance for evaluating explosion risks associated with EA/H2/air mixtures and for designing related combustion devices.