Yttrium doping has been reported to be an effective approach to enhance the mechanical and protective properties of ZrN coatings by magnetron sputtering. Nitrogen (N2) flow ratio during reactive magnetron sputtering is known to critically influence the stoichiometry, defect structure, and microstructure of nitride coatings. However, its systematic effect on Y-doped ZrN (ZrYN) coatings has remained unexplored. In this work, ZrYN coatings with a fixed Y content were deposited by reactive magnetron sputtering under varying N2 flow ratios (0–10%). Their microstructure, mechanical properties, corrosion resistance in 3.5 wt% NaCl solution, and oxidation behavior at 650 °C were systematically investigated. Below 5% N2 flow ratio, the coatings are metallic ZrY, showing very low hardness, poor corrosion resistance, and catastrophic oxidation failure. At N2 flow ratio ≥ 5%, cubic ZrYN forms, with stoichiometry varying from sub-stoichiometric (5%) to near-stoichiometric (7.5%) to over-stoichiometric (10%). The near-stoichiometric coating at 7.5% exhibits the finest columnar grains and densest microstructure, leading to the highest hardness (32.2 ± 1.4 GPa) and an elastic modulus of (469.6 ± 24.5 GPa), as well as the best corrosion resistance (two orders of magnitude lower than bare 316 stainless steel). Upon oxidation, it forms a thin and dense epitaxial t-ZrO2 scale stabilized by Y2O3, suppressing the destructive tetragonal to monoclinic transformation. Off-stoichiometric coatings at 5% and 10% develop thicker, cracked oxide scales and show inferior properties. Precise control of N2 flow ratio is therefore essential to achieve a near-stoichiometric ZrYN coating with superior mechanical, anti-corrosion, and anti-oxidation performance.
This study systematically investigated the influence of aluminum nitride (AlN) addition on the microstructure and mechanical properties of Ti(C,N)-based cermets with low Ni/Co and high N contents. The results demonstrate that AlN addition does not alter the phase composition of Ti(C,N)-based cermets, and their microstructure retains the characteristic core–rim morphology. The dissolution of Al atoms from AlN effectively suppressed abnormal growth of Ti(C,N) grains and enhanced the mechanical stability of the binder. Densification and comprehensive mechanical properties strongly depended on the AlN content. Both parameters initially improved with the addition of AlN, peaked at an optimal content of 1.0 wt.%, and then declined upon further addition due to the formation of micropores and brittle agglomerates of Al2O3. At the optimal AlN content of 1.0 wt.%, the cermets demonstrated peak performance: a Vickers hardness of 1676 HV30, a transverse rupture strength of 1486 MPa, and a fracture toughness of 8.8 MPa·m1/2. The results elucidate the dual role of AlN as both a microstructural refiner and a precursor for in situ strengthening of the binder phase.
24 August 2026 in Journal of Colloid and Interface Science
Crystal engineering of manganese nitride thin film electrodes for all-nitride Mn 3 N 2 ‖VN asymmetric supercapacitors with a maximum energy density of 153.1 mWh cm −3 and power density of 53.7 W cm −3 .