Jinlong Yuan

Prof. Jinlong Yuan

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 March 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Jinlong YuanJinlong Yuan
Jinlong Yuan
LSLian Su
Lian Su
HXHaiyun Xia
Haiyun Xia
YLYi Li
Yi Li
MZMing Zhang
Ming Zhang
JLJianyu Li
Jianyu Li
Accurate wind shear detection is crucial for aviation safety, especially in landing and departure. A new approach for windshear alerting is proposed and demonstrated. This approach monitors orthogonal wind components in multiple runways using single coherent Doppler wind lidar (CDWL). First, the two orthogonal components of the wind field are retrieved from radial speed by an updated variational method. Then, the heading wind and cross wind on different runways are calculated simultaneously, without the location restriction of the single lidar. Finally, a windshear alerting message is generated through quantitatively evaluating the distribution of shear ramps over the monitoring area. The new CDWL-based approach for windshear alerting is implemented at the Beijing Daxing International Airport. The retrieved horizontal wind from the lidar is consistent with that from anemometers. Thanks to its high spatial/temporal resolution, some meteorological phenomena of aviation hazards, including microburst, windshear, gust front, and vortex are well captured. Particularly, all 10 windshear cases reported by crews are successfully identified during the windshear verification experiment, demonstrating the effectiveness and robustness of the new approach.

20 June 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
PJPu Jiang
Pu Jiang
Jinlong YuanJinlong Yuan
Jinlong Yuan
KWKenan Wu
Kenan Wu
LWLu Wang
Lu Wang
HXHaiyun Xia
Haiyun Xia
The refractive index structure constant (Cn2) is a key parameter used in describing the influence of turbulence on laser transmissions in the atmosphere. Three different methods for estimating Cn2 were analyzed in detail. A new method that uses a combination of these methods for continuous Cn2 profiling with both high temporal and spatial resolution is proposed and demonstrated. Under the assumption of the Kolmogorov “2/3 law”, the Cn2 profile can be calculated by using the wind field and turbulent kinetic energy dissipation rate (TKEDR) measured by coherent Doppler wind lidar (CDWL) and other meteorological parameters derived from a microwave radiometer (MWR). In a horizontal experiment, a comparison between the results from our new method and measurements made by a large aperture scintillometer (LAS) is conducted. The correlation coefficient, mean error, and standard deviation between them in a six-day observation are 0.8073, 8.18 × 10−16 m−2/3 and 1.27 × 10−15 m−2/3, respectively. In the vertical direction, the continuous profiling results of Cn2 and other turbulence parameters with high resolution in the atmospheric boundary layer (ABL) are retrieved. In addition, the limitation and uncertainty of this method under different circumstances were analyzed, which shows that the relative error of Cn2 estimation normally does not exceed 30% under the convective boundary layer (CBL).

23 September 2021 in Remote Sensing
Verified
Journal Article
Open access
PDF file
Jinlong YuanJinlong Yuan
Jinlong Yuan
KWKenan Wu
Kenan Wu
Tianwen WeiTianwen Wei
Tianwen Wei
LWLu Wang
Lu Wang
Zhifeng ShuZhifeng Shu
Zhifeng Shu
HXHaiyun Xia
Haiyun Xia
Evaluation of the cloud seeding effect is a challenge due to lack of directly physical observational evidence. In this study, an approach for directly observing the cloud seeding effect is proposed using a 1548 nm coherent Doppler wind lidar (CDWL). Normalized skewness was employed to identify the components of the reflectivity spectrum. The spectrum detection capability of a CDWL was verified by a 24.23-GHz Micro Rain Radar (MRR) in Hefei, China (117°15′ E, 31°50′ N), and different types of lidar spectra were detected and separated, including aerosol, turbulence, cloud droplet, and precipitation. Spectrum analysis was applied as a field experiment performed in Inner Mongolia, China (112°39′ E, 42°21′ N ) to support the cloud seeding operation for the 70th anniversary of China’s national day. The CDWL can monitor the cloud motion and provide windshear and turbulence information ensuring operation safety. The cloud-precipitation process is detected by the CDWL, microwave radiometer (MWR) and Advanced Geosynchronous Radiation Imager (AGRI) in FY4A satellites. In particular, the spectrum width and skewness of seeded cloud show a two-layer structure, which reflects cloud component changes, and it is possibly related to cloud seeding effects. Multi-component spectra are separated into four clusters, which are well distinguished by spectrum width and vertical velocity. In general, our findings provide new evidence that the reflectivity spectrum of CDWL has potential for assessing cloud seeding effects.

14 October 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
YYYue Yue
Yue Yue
SYSaifen Yu
Saifen Yu
MLmanyi li
manyi li
Tianwen WeiTianwen Wei
Tianwen Wei
Jinlong YuanJinlong Yuan
Jinlong Yuan
HXHaiyun Xia
Haiyun Xia
A micro-pulse lidar system incorporating differential absorption lidar (DIAL) and coherent Doppler wind lidar (CDWL) is proposed and demonstrated. Due to the high signal-to-noise ratio (SNR) of the superconducting nanowire single-photon detector (SNSPD), the DIAL channel achieves high sensitivity in CO2 measurement. Meanwhile, the CDWL channel is used to obtain the horizontal wind field. In the process of the optimization and calibration of the DIAL receiver, specifically, mode scrambling and temperature control of the connecting fiber between the telescope and the SNSPD enhance the stability and robustness of the system. Horizontal scanning of the CO2 concentration and the wind field is carried out in a 6 km range over a scanning span of 60° with a radial resolution of 150 m and 15 s. The results show that the hybrid lidar system captures the spatial distribution of CO2 concentration and the wind field simultaneously. The horizontal net CO2 flux in a radius of 6 km is estimated by integrating the CO2 concentration and the wind transport vector, indicating different characteristics of horizontal net CO2 fluxes in an industrial area, a university campus, and a park. During most of the experiment, CO2 flux remained positive in the industrial area, but balances fell to nearly zero on the campus and in the park. The horizontal net fluxes averaged over 24 h in the three areas are 3.5 × 105 ppm·m2·s−1, 0.7 × 105 ppm·m2·s−1, and 0.1 × 105 ppm·m2·s−1.

5 February 2022 in Remote Sensing
Verified
Journal Article
Open access
PDF file
LWLu Wang
Lu Wang
Jinlong YuanJinlong Yuan
Jinlong Yuan
HXHaiyun Xia
Haiyun Xia
LZLijie Zhao
Lijie Zhao
YWYunbin Wu
Yunbin Wu
Marine mixed layer height (MLH) detection using a ship-borne coherent Doppler wind lidar (CDWL) based on a constant turbulent kinetic energy dissipation rate (TKEDR) threshold is realized and experimentally demonstrated. The MLH can be retrieved from the TKEDR estimated by the CDWL via setting an appropriate threshold. Here, the value of threshold is determined by a reference MLH retrieved from aerosol backscattered signal. The threshold of 10−4 m2 s−3 is found to be applicable in retrieving both inland and marine MLHs. In the experiments, to validate the reliability of the constant threshold, the MLH diurnal cycles at inland and marine sites are retrieved by using a ground-based CDWL. The MLH retrieval result at the marine site shows good agreement with radiosonde-derived MLH. After that, by using a ship-borne CDWL, the marine MLH along the ship’s route in South China Sea is successfully detected in real time.

6 March 2024 in Remote Sensing
Verified
Journal Article
Open access
PDF file
HXHaiyun Xia
Haiyun Xia
YCYixiang Chen
Yixiang Chen
Jinlong YuanJinlong Yuan
Jinlong Yuan
LSLian Su
Lian Su
ZYZhu Yuan
Zhu Yuan
DZDexian Zhao
Dexian Zhao
Convective weather is often accompanied by precipitation and windshear, seriously endangering the safety of aircraft during takeoff and landing. However, under rainfall conditions, conventional wind lidars have a limited detection range due to significant signal attenuation. To solve this problem, a 200 mm temperature-controlled telescope coated with a hydrophobic film is applied in the coherent Doppler wind lidar system to improve the detection capability in rain. The maximum detection range of the lidar is extended to 30 km and demonstrated at Kunming Changshui International Airport at an altitude of 2102 m. Firstly, the detection accuracy and maximum detection range of the lidar are verified. Through the analysis of the horizontal wind field under two typical convective weather conditions, it is found that convective weather often accompanies low-level convergence and divergence structures, leading to headwind shear and crosswind shear on the airport runway. From the vertical profile, it is shown that the triggering of convective weather is accompanied by low-level southwest winds and high-altitude northeastern winds. According to the statistics of wind speed and direction on clear and rainy days over 9 months, rainy days are usually caused by the invasion of cold air from Northeast China, resulting in airport windshear. In summary, the enhanced lidar can effectively identify and analyze windshear during rainy days, which is very useful for aviation safety, especially for takeoff and landing in all weather conditions.