To examine the utilization of metal oxide nanoparticles (NPs) in different commercial products, this work focuses on the determination of cost-effective and scalable synthesis protocols. The solvothermal protocol is well-known as a scalable method but has recently been shown to lack economic feasibility. The mechanochemical method has recently been recognized to be a more economic and environmentally friendly substitute for the solvothermal method. In this study, zinc oxide nanoparticles (ZnO NPs) and copper oxide nanoparticles (CuO NPs) were synthesized using two (aqueous and organic) solvothermal (wet) methods and two (manual and automated) mechanochemical (dry) methods. The four methods were evaluated and compared. The automated mechanochemical method generated a significantly higher yield of ZnO NPs (82%) and CuO NPs (84%) using the least energy and time. However, the prepared ZnO NPs displayed higher cytotoxicity against Vero E6 cells when compared to that of CuO NPs. Because of their low cytotoxicity, CuO NPs synthesized via the automated mechanochemical method were selected for application onto cotton fabrics. Lower cytotoxicity was observed for CuO NPs treated fabrics with an IC50 of 562 mg/mL and ZnO treated fabrics with an IC50 at 23.93 mg/mL when the treated fabrics were tested against L929 fibroblast cells. Additionally, the cotton fabrics retained bactericidal and virucidal effects after four washes. Thus, the current study recommends the automated mechanochemical method as a cost-effective scalable approach for the synthesis of CuO NPs. The application of CuO NPs onto cotton fabrics generated washable antimicrobial face masks.

Carboplatin (Cp) is a potent chemotherapeutic agent, but its effectiveness is constrained by its associated side effects. Frankincense, an oleo-gum resin from the Boswellia sacra tree, has demonstrated cytotoxic activity against cancer cells. This study explored the synergistic potential of nanoparticles formulated from Boswellia sacra methanolic extract (BME), to enhance the therapeutic efficacy of Cp at reduced doses. Nanoparticles were prepared via the nanoprecipitation method, loaded with Cp, and coated with positively charged chitosan (CS) for enhanced cell interaction, yielding Cp@CS/BME NPs with an average size of 160.2 ± 4.6 nm and a zeta potential of 12.7 ± 1.5 mV. In vitro release studies revealed a pH-sensitive release profile, with higher release rates at pH 5.4 than at pH 7.4, highlighting the potential for targeted drug delivery in acidic tumor environments. In vitro studies on HT-29 and Caco-2 colorectal cancer cell lines demonstrated the nanoformulation’s ability to significantly increase Cp uptake and cytotoxic activity. Apoptosis assays further confirmed increased induction of cell death with Cp@CS/BME NPs. Cell-cycle analysis revealed that treatment with Cp@CS/BME NPs led to a significant increase in the sub-G1 phase, indicative of enhanced apoptosis, and a marked decrease in the G1-phase population coupled with an increased G2/M-phase arrest in both cell lines. Further gene expression analysis demonstrated a substantial downregulation of the anti-apoptotic gene Bcl-2 and an upregulation of the pro-apoptotic genes Bax, PUMA, and BID following treatment with Cp@CS/BME NPs. Thus, this study presents a promising and innovative strategy for enhancing the therapeutic efficacy of chemotherapeutic agents using naturally derived ingredients while limiting the side effects.

Chemotherapy is still the mainstay of treatment for triple-negative breast cancer (TNBC) patients. Yet only 20% of TNBC patients show a pathologic complete response (pCR) after neoadjuvant chemotherapy. 5-Fluorouracil (5-FU) is a stable cornerstone in all recommended chemotherapeutic protocols for TNBC patients. However, TNBC patients’ innate or acquired chemoresistance rate for 5-FU is steeply escalating. This study aims to unravel the mechanism behind the chemoresistance of 5-FU in the aggressive TNBC cell line, MDA-MB-231 cells, to explore further the role of the tumor suppressor microRNAs (miRNAs), miR-1275, miR-615-5p, and Let-7i, in relieving the 5-FU chemoresistance in TNBC, and to finally provide a translational therapeutic approach to co-deliver 5-FU and the respective miRNA oligonucleotides using chitosan-based nanoparticles (CsNPs). In this regard, cellular viability and proliferation were investigated using MTT and BrdU assays, respectively. 5-FU was found to induce JAK/STAT and PI3K/Akt/mTOR pathways in MDA-MB-231 cells with contaminant repression of their upstream regulators miR-1275, miR-615-5p, and Let-7i. Moreover, CsNPs prepared using the ionic gelation method were chosen and studied as nanovectors of 5-FU and a combination of miRNA oligonucleotides targeting TNBC. The average particle sizes, surface charges, and morphologies of the different CsNPs were characterized using dynamic light scattering (DLS) and transmission electron microscopy (TEM), respectively. In addition, the encapsulation efficiency (EE%), drug loading capacity (DLC%), and release manner at two different pH values were assessed. In conclusion, the novel CsNPs co-loaded with 5-FU and the combination of the three miRNA oligonucleotides demonstrated synergistic activity and remarkable repression in cellular viability and proliferation of TNBC cells through alleviating the chemoresistance to 5-FU.

Currently, the main pillars in treating breast cancer involve tumorectomy pursued by hormonal, radio, or chemotherapies. Nonetheless, these approaches exhibit severe adverse effects and might suffer from tumor recurrence. Therefore, there is a considerable demand to fabricate an innovative controlled-release nano-delivery system to be implanted after tumor surgical removal to guard against cancer recurrence. In addition, combining platinum-based drugs with phytochemicals is a promising approach to improving the anticancer activity of the chemotherapeutics against tumor cells while minimizing their systemic effects. This study designed polycaprolactone (PCL)-based electrospun nanofiber mats encapsulating nedaplatin (N) and Peganum harmala alkaloid-rich fraction (L). In addition to physicochemical characterization, including average diameters, morphological features, degradation study, thermal stability, and release kinetics study, the formulated nanofibers were assessed in terms of cytotoxicity, where they demonstrated potentiated effects and higher selectivity towards breast cancer cells. The dual-loaded nanofiber mats (N + L@PCL) demonstrated the highest antiproliferative effects against MCF-7 cells with a recorded IC50 of 3.21 µg/mL, as well as the topmost achieved selectivity index (20.45) towards cancer cells amongst all the tested agents (N, L, N@PCL, and L@PCL). This indicates that the dual-loaded nanofiber excelled at conserving the normal breast epithelial cells (MCF-10A). The combined therapy, N + L@PCL treatment, resulted in a significantly higher percent cell population in the late apoptosis and necrosis quartiles as compared to all other treatment groups (p-value of ≤0.001). Moreover, this study of cell cycle kinetics revealed potentiated effects of the dual-loaded nanofiber (N + L@PCL) at trapping more than 90% of cells in the sub-G1 phase and reducing the number of cells undergoing DNA synthesis in the S-phase by 15-fold as compared to nontreated cells; hence, causing cessation of the cell cycle and confirming the apoptosis assay results. As such, our findings suggest the potential use of the designed nanofiber mats as perfect implants to prevent tumor recurrence after tumorectomy.

Chemoresistance encountered using conventional chemotherapy demands novel treatment approaches. Asplatin (Asp), a novel platinum (IV) prodrug designed to release cisplatin and aspirin in a reductive environment, has demonstrated high cytotoxicity at reduced drug resistance. Herein, we investigated the ability of green-synthesized nanocarriers to enhance Asp’s efficacy. Zinc oxide nanoparticles (ZnO-NPs) were synthesized using a green microwave-assisted method with the reducing and capping agent gambogic acid (GA). These nanoparticles were then loaded with Asp, yielding Asp@ZnO-NPs. Transmission electron microscopy was utilized to study the morphological features of ZnO-NPs. Cell viability studies conducted on MDA-MB-231 breast cancer cells demonstrated the ability of the Asp@ZnO-NPs treatment to significantly decrease Asp’s half-maximal inhibitory concentration (IC₅₀) (5 ± 1 µg/mL). This was further demonstrated using flow cytometric analysis that revealed the capacity of Asp@ZnO-NPs treatment to significantly increase late apoptotic fractions. Furthermore, in vivo studies carried out using solid Ehrlich carcinoma-bearing mice showed significant tumor volume reduction with the Asp@ZnO-NPs treatment (156.3 ± 7.6 mm³), compared to Asp alone (202.3 ± 8.4 mm³) and untreated controls (342.6 ± 10.3 mm³). The histopathological analysis further demonstrated the increased necrosis in Asp@ZnO-NPs-treated group. This study revealed that Asp@ZnO-NPs, synthesized using an eco-friendly approach, significantly enhanced Asp’s anticancer activity, offering a sustainable solution for potent anticancer formulations.