Recently, lithium-sulfur (Li-S) batteries have been greeted by a huge ovation owing to their very high theoretical specific capacity (1675 mAh·g−1) and theoretical energy density (2600 Wh·kg−1). However, the full commercialization of Li-S batteries is still hindered by dramatic capacity fading resulting from the notorious “shuttle effect” of polysulfides. Herein, we first describe the development of a facile, inexpensive, and high-producing strategy for the fabrication of N-, O-, and S-tri-doped porous carbon (NOSPC) via pyrolysis of natural wheat straw, followed by KOH activation. The as-obtained NOSPC shows characteristic features of a highly porous carbon frame, ultrahigh specific surface area (3101.8 m2·g−1), large pore volume (1.92 cm3·g−1), good electrical conductivity, and in situ nitrogen (1.36 at %), oxygen (7.43 at %), and sulfur (0.7 at %) tri-doping. The NOSPC is afterwards selected to fabricate the NOSPC-sulfur (NOSPC/S) composite for the Li-S batteries cathode material. The as-prepared NOSPC/S cathode delivers a large initial discharge capacity (1049.2 mAh·g−1 at 0.2 C), good cycling stability (retains a reversible capacity of 454.7 mAh·g−1 over 500 cycles at 1 C with a low capacity decay of 0.088% per cycle), and superior rate performance (619.2 mAh·g−1 at 2 C). The excellent electrochemical performance is mainly attributed to the synergistic effects of structural restriction and multidimensional chemical adsorptions for cooperatively repressing the polysulfides shuttle.
In the study of coal pore structure, the traditional test method does not consider the influence of coal particle size. During the crushing process, coal samples are affected by crushing stress. While the particle size changes, the change characteristics of pore structure and macromolecular structure are a matter for which systematic research is still lacking. In this paper, mercury injection and liquid nitrogen were used to characterize the pore structure of coal. It was found that the porosity, total pore volume and total specific surface area of the coal increased with the decrease of particle size. However, during this process, the pore volume of macropores and mesopores decreases, while the micropores and transition pores increase significantly, indicating that while the particle size decreases, macropores and mesopores are broken into micropores and transition pores. In addition, the pore structure of samples with a particle size less than 200 mesh changes significantly. With the decrease of coal particle size, the areas of the D peak and G peak of the Raman spectrum increase, indicating that the ordering degree of coal increases. Finally, the statistical results of the peak area of the Fourier infrared spectrum show that alcohol, phenol, ammonia hydroxyl and fatty hydrocarbon CH2 and CH3 are greatly reduced, while the out-of-plane deformation vibration of alkyl ether and aromatic structure C–H are significantly increased, which also indicates the transformation of the coal macromolecular structure to an aromatic structure with strong stability.
Small fault area in coal mine has great risk of coal and gas outburst. However, the damage effect of small faults on coal pore structure still lacks systematic research. Taking a small reverse fault under Pingmei No. 2 mine as an example, this paper collects the hanging wall coal samples within 5 m from the fault plane and the coal samples 50 m from the fault plane, where there is no fault development. The pore structure characteristics of the two coal samples were analyzed and compared by means of a scanning electron microscope, mercury injection, liquid nitrogen adsorption, and Raman spectroscopy. The test results show that compared with the coal samples without faults, the coal samples at faults form micron-scale fracture zones with constant spacing, stable occurrence, and flat two walls. The pore volume and pore specific surface area of different pore sizes increase, the pore peak of mesopore (100~1000 nm) shifts from 1000 nm to 200~400 nm, and its connectivity is enhanced. The number of micropores (<10 nm) increased significantly, and the ink bottle type pores developed. Faulting also has a certain impact on the macromolecular structure of coal, which shows that the D peak area decreases and the area of G peak increases, indicating that the order degree of macromolecular structure of coal increases.
The diffusion coefficient (D) is a key parameter that characterizes the gas transport occurring in coal seams. Typically, D is calculated using the desorption curve of particle coal. However, this method cannot accurately reflect the diffusion characteristics under the stress constraint conditions of in situ coal seams. In this study, different metamorphic deformed coals of medium and high coal rank were considered based on Fick’s law of counter diffusion. The change laws of D under different confining pressures, gas pressures, and temperature conditions were tested and analyzed, and the influencing mechanisms on D are discussed. The results showed that D of different metamorphic deformed coals exponentially decreased with an increase in confining pressures, and exponentially increased with increases in gas pressures and temperature. There is a limit diffusion coefficient. The influence of the confining pressure on D can essentially be determined by changes in the effective stress, and D negatively affects the effective stress, similar to permeability. The effect of gas pressure on D involves two mechanisms: mechanical and adsorption effects, which are jointly restricted by the effective stress and the shrinkage and expansion deformation of coal particles. Temperature mainly affects D by changing the root-mean-square speed and average free path of the gas molecules. Under the same temperature and pressure conditions, D first increased and then decreased with an increase in the degree of deformation. D of the fragmented coal was the largest. Under similar deformation conditions, D of the high-rank anthracite was larger than that of the medium-rank fat coal. Porosity is a key factor affecting the change in D in different metamorphic deformed coals.
Hollow carbon nanocapsules have been attracting growing interest due to their fascinating characteristics and extensive potential applications. In this work, a novel natural halloysite-templated synthesis approach for highly graphitic boron-doped hollow carbon nanocapsule webs (B-HCNCWs) using glucose as the carbon source and boric acid as the heteroatom dopant was first reported. The formation process and physicochemical properties of B-HCNCWs were revealed by SEM, TEM, XRD, Raman, Brunauer–Emmett–Teller (BET), and XPS characterization techniques. The outcomes showed that the as-obtained B-HCNCWs with hollow nanocapsule network architecture had a specific surface area of 263 m2 g−1, a pore volume of 0.8 cm3 g−1, a high degree of graphitization (81.4%), graphite-like interplanar spacing (0.3370 nm), and B-containing functional groups (0.77 at%). The density function theory (DFT) calculation demonstrated that the adsorption energies of Li on B-HCNCWs were much higher than that of HCNCWs, which proved that B-doping in a carbon matrix could increase the lithium intercalation capacity.
The diffusion coefficient (D) is a key parameter characterizing gas transport in coal seams. Usually, the D is calculated from the desorption curve of particle coal, which cannot accurately reflect the diffusion characteristics under the stress constraint conditions of in-situ coal seams. In this paper, based on Fick's law of counter diffusion, different metamorphic deformed coals of medium and high coal rank are taken as the research object. The change laws of D under different confining pressure, gas pressure, and temperature conditions are tested and analyzed, and the influencing mechanisms on the D are discussed. The results show that the D of different metamorphic deformed coals decreases exponentially with the increase of confining pressure, and increases exponentially with the increase of gas pressure and temperature. There is a limit diffusion coefficient. The influence of confining pressure on the D is essentially determined by the change of effective stress, and the D has a negative effect of effective stress similar to permeability. The effect of gas pressure on the D involves two mechanisms, namely, mechanical and adsorption effects, which are jointly restricted by effective stress and coal particle shrinkage and expansion deformation. The effect of temperature on the D is mainly achieved by changing the root mean square speed and average free path of gas molecules. Under the same temperature and pressure conditions, the D increases first and then decreases with the increase of deformation degree, and the D of fragmented coal is the largest. Under similar deformation conditions, the D of high-rank anthracite is greater than that of medium-rank fat coal. It is considered that porosity is the key factor affecting the change of D in different metamorphic deformed coals.