Chengtao Yang

Chengtao Yang

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 January 2023 in Frontiers in Earth Science
Verified
Journal Article
Open access
PJPeiwen Jiang
Peiwen Jiang
CYChengtao Yang
Chengtao Yang
FCFeng Chen
Feng Chen
BLBing Li
Bing Li
JRJiangang Ren
Jiangang Ren
ZSZhimin Song
Zhimin Song
Elucidating the evolution law of coal pore structure under acidification is crucial for guiding the practical application of acidizing technology and improving the production of coalbed methane. To comprehensively investigate the influence of acidification on varied-sized pores in different rank coals, in this study, fat coal, meagre coal and anthracite coal were collected and acidified with a mixed solution composed of hydrochloric acid (9 wt%) and hydrofluoric acid (3 wt%). An approach integrating low-pressure CO2 adsorption (LPGA-CO2), low-temperature N2 adsorption (LTGA-N2) and Mercury intrusion porosimetry (MIP) was adopted to fully characterize the varied-sized pore structure before and after acidification to eliminate the limitations of single method. The results demonstrated that acid treatment improved the pore opening degree and connectivity in coal, but had essentially no effect on the pore shape. After acidification, all the coal samples showed significant increases in the porosity and total pore volume, which was mainly contributed by the numerous newly formed large mesopores and macropores, especially the macropores (with an average contribution rate of 74.59%). Taken as a whole, acid treatment had the largest impact on macropores, followed by mesopores, and the smallest impact on micropores. In addition, the variation trend of total specific surface area (SSA) under acidification was primarily determined by micropores. For the three different rank coals selected in this study, the total SSA of fat coal (PM) was more easily affected by acidification and had the largest percentage increase after acid treatment, followed by anthracite coal (YM), while that of meagre coal (LA) decreased slightly. This difference was driven primarily by the different variation trend of micropore SSA in different rank coals. After acidification, the SSA of ultra-micropores and super-micropores all increased in fat coal (PM) and anthracite coal (YM), whereas for meagre coal (LA), although ultra-micropores SSA increased, super-micropores SSA decreased, which ultimately led to the slight decrease of its micropore SSA. Moreover, the total pore volume increment of coal was closely related to the macropore volume increment under acidification, but not significantly related to the coal maturity,which might indicate that, compared with coal rank, the mineral content in coal might be a more important consideration when measuring the applicability of acidification technology.

15 August 2023 in Processes
Verified
Journal Article
Open access
PDF file
JLJianbao Liu
Jianbao Liu
ZSZhimin Song
Zhimin Song
CYChengtao Yang
Chengtao Yang
BLBing Li
Bing Li
JRJiangang Ren
Jiangang Ren
SCShengjie Chen
Shengjie Chen
Coal permeability data are critical in the prevention and control of coal and gas outbursts in mines and are an important reservoir parameter for the development of coalbed methane. The mechanism by which permeability is affected by gas pressure is complex. We used a self-developed true triaxial seepage experimental device that collects lignite and anthracite coal samples, sets fixed axial pressure and confining pressure, and changes gas pressure by changing the orientation of the coal seam to study the influence of the gas pressure on the permeability of the coal seam under the conditions of different coal types and different bedding orientations. Coal permeability decreased rapidly and then decreased slowly and tended to be stable with the increase in gas pressure. This conformed to the power exponential fitting relationship, and the fitting degree reached more than 99%. The comparison of the two anthracite coal samples showed that the sample’s permeability with a bedding plane vertical to the seepage direction was significantly lower than that of the bedding plane parallel to the seepage direction, indicating that gas seeped more easily along the bedding. The sensitivity coefficient of permeability with the change in gas pressure was calculated. The analysis showed that coal permeability was sensitive to changes in gas pressure during the low-pressure stage. When the gas pressure was greater than 0.8 MPa, the sensitivity coefficient was significantly reduced, which may have been related to the slow increase in the amount of gas absorbed by the coal seam in the high-pressure stage. A theoretical calculation model of coal seam permeability considering adsorption/desorption and seepage effects was proposed and then verified with experimental results showing that the theoretical model better reflected the permeability characteristics of coal and predicted its permeability. Using the finite element simulation software COMSOL, the extraction efficiency of the coal seam gas under different gas pressure conditions was simulated. The results showed that coal permeability and extraction efficiency decreased with an increase in gas pressure. In the low-pressure stage, the reduction in the extraction efficiency was more evident than that in the high-pressure stage.

3 October 2022 in Geofluids
Verified
Journal Article
Open access
PDF file
JLjianbao liu
jianbao liu
ZSZhimin Song
Zhimin Song
BLBing Li
Bing Li
JRJiangang Ren
Jiangang Ren
FCFeng Chen
Feng Chen
CYChengtao Yang
Chengtao Yang
Small fault area in coal mine has great risk of coal and gas outburst. However, the damage effect of small faults on coal pore structure still lacks systematic research. Taking a small reverse fault under Pingmei No. 2 mine as an example, this paper collects the hanging wall coal samples within 5 m from the fault plane and the coal samples 50 m from the fault plane, where there is no fault development. The pore structure characteristics of the two coal samples were analyzed and compared by means of a scanning electron microscope, mercury injection, liquid nitrogen adsorption, and Raman spectroscopy. The test results show that compared with the coal samples without faults, the coal samples at faults form micron-scale fracture zones with constant spacing, stable occurrence, and flat two walls. The pore volume and pore specific surface area of different pore sizes increase, the pore peak of mesopore (100~1000 nm) shifts from 1000 nm to 200~400 nm, and its connectivity is enhanced. The number of micropores (<10 nm) increased significantly, and the ink bottle type pores developed. Faulting also has a certain impact on the macromolecular structure of coal, which shows that the D peak area decreases and the area of G peak increases, indicating that the order degree of macromolecular structure of coal increases.

27 September 2022 in Frontiers in Earth Science
Verified
Journal Article
Open access
JLJianbao Liu
Jianbao Liu
ZSZhimin Song
Zhimin Song
CYChengtao Yang
Chengtao Yang
BLBing Li
Bing Li
JRJiangang Ren
Jiangang Ren
MXMing Xiao
Ming Xiao
The permeability of coal is a key parameter affecting coal and gas outbursts and coal seam gas drainage. The permeability is clearly affected by geo-stress. In this study, the influence of the axial pressure on the permeability of the coal seam was studied using a self-developed true triaxial stress permeability experimental device to set fixed gas and confining pressures, and to change the magnitude of the axial pressure. The experimental results show a polynomial relationship between the axial pressure and the permeability of the coal seam. With an increase in axial pressure, the permeability initially decreased slightly and then increased gradually. When the axial pressure exceeded 30 MPa, the permeability of the coal seam sharply increased. This may be due to plastic deformation of the coal seam under a large axial pressure, resulting in new fractures and significantly improving the permeability of the coal seam. Using the COMSOL numerical simulation software, the effect of in situ stress on the coal seam gas drainage efficiency was calculated by comprehensively considering the adsorption/desorption, diffusion, and seepage of gas. The calculation results show that with an increase in the axial pressure, the gas drainage efficiency of the coal seam increases continuously. As the axial pressure increased from 5 to 30 MPa, the gas drainage efficiency increased to 2–3 times that of the original value.

12 July 2023 in Preprints.org
Verified
Preprint
Open access
PDF file
JLjianbao liu
jianbao liu
ZSZhimin Song
Zhimin Song
CYChengtao Yang
Chengtao Yang
BLBing Li
Bing Li
JRJiangang Ren
Jiangang Ren
SCShengjie Chen
Shengjie Chen
Coal permeability data are critical in the prevention and control of coal and gas outbursts in mines and are an important reservoir parameter for the development of coalbed methane. The mechanism by which permeability is affected by gas pressure is complex. We used a self-developed true triaxial seepage experimental device that collects lignite and anthracite coal samples, sets fixed axial pressure and confining pressure, and changes gas pressure by changing the orientation of the coal seam to study the influence of the gas pressure on the permeability of the coal seam under the conditions of different coal types and different bedding orientations. Coal permeability decreased rapidly and then decreased slowly and tended to be stable with the increase in gas pressure. This conforms to the power exponential fitting relationship, and the fitting degree reaches more than 99%. The permeabilities of lignite and anthracite were basically the same under various pressure conditions, indicating that the influence of coal type on coal permeability was not significant. The comparison of the two anthracite coal samples showed that the sample's permeability with a bedding plane vertical to the seepage direction was significantly lower than that of the bedding plane parallel to the seepage direction, indicating that gas seeped more easily along the bedding. The sensitivity coefficient of permeability with the change in gas pressure was calculated. The analysis showed that coal permeability was sensitive to changes in gas pressure during the low-pressure stage. When the gas pressure was greater than 0.8 MPa, the sensitivity coefficient was significantly reduced, which may be related to the slow increase in the amount of gas absorbed by the coal seam in the high-pressure stage. A theoretical calculation model of coal seam permeability considering adsorption/desorption and seepage effects was proposed and then verified with experimental results showing that the theoretical model better reflected the permeability characteristics of coal and predicted its permeability. Using the finite element simulation software COMSOL, the extraction efficiency of the coal seam gas under different gas pressure conditions was simulated. The results showed that with an increase in gas pressure, coal permeability and extraction efficiency decreased. In the low-pressure stage, the reduction in the extraction efficiency was more obvious than that in the high-pressure stage.

1 April 2026 in Fractal and Fractional
Verified
Journal Article
Open access
PDF file
JRJiangang Ren
Jiangang Ren
BLBing Li
Bing Li
XWXiaoming Wang
Xiaoming Wang
FZFan Zhang
Fan Zhang
CYChengtao Yang
Chengtao Yang
ZSZhimin Song
Zhimin Song
The dominant pores governing methane adsorption in coal are micropores (pore size < 2 nm). Their spatial heterogeneity can be quantitatively characterized using multifractal theory; however, the evolution patterns and mechanisms of microporous structures across different coalification degrees remain unclear. This research selected a series of coal samples from different ranks and identified the coalification degree using the maximum vitrinite reflectance (Rₒ,max). By comprehensively employing low-temperature CO2 adsorption experiments and multifractal analysis, the evolution patterns of the microporous structures and their multifractal spectral parameters were systematically revealed, and the underlying control mechanisms were explored. Results indicate that micropore volume (PV) and specific surface area (SSA) first exhibit a decrease and then increase as Rₒ,max increases, with the trough occurring during the second coalification jump at Rₒ,max = 1.2–1.4%. The pore sizes exhibit bimodal distributions, with the primary peak occurring in the range of 0.45–0.65 nm and the secondary peak occurring in the range of 0.8–0.9 nm. All microporous structures possess pronounced multifractal characteristics. The generalized dimension spectrum width (ΔD) and singularity spectrum width (Δα) exhibit an increasing–decreasing–increasing trend with Rₒ,max, whereas the Hurst exponent (H) follows an inverted parabolic curve, first increases then decreases. This contrasts with the trends in PV and SSA, indicating that the evolution of pore-space heterogeneity and connectivity is independent of and lags the changes in micropore quantity. These patterns are governed by a structural phase transition within the coal macromolecular network. Marked by the second coalification jump, the microporous system shifts from a flexible degradation–polycondensation paradigm to a rigid ordering–construction paradigm. This transition drives the asynchronous, synergistic evolutions of pore quantity, spatial heterogeneity (ΔD and Δα), and topological connectivity (H). This research provides a theoretical basis for quantitatively evaluating pore heterogeneity in coal reservoirs.