Automatic maintenance of components within fusion reactors requires precise force perception, typically achieved by installing force/torque (F/T) sensor on the robot’s wrist. However, the force measured by F/T sensor include not only contact force but also non-contact force and associated torques, such as end-effector gravity, inertial force and sensor zero offsets. Inertial force can be ignored due to the low operational speed and small speed variation during the maintenance. In this paper, we propose a novel non-contact force compensation method, which can estimate gravity and centroid of tool and load, sensor zero offsets, as well as robot installation and sensor installation offsets. The Gröbner basis method is used to estimate the gravity of the tool and load in robot base frame and the orientation offsets between the robot end and F/T sensor. The constraints of rotation matrix are naturally satisfied with the quaternion parameterization. All the parameters can be estimated with only three measurements. A non-linear least squares method is employed to refine estimation results by utilizing all available measurements, thereby enhancing the estimation reliability. A comparative study, incorporating both simulations and experiments, was conducted. The results show that our method outperforms the existing methods in various aspects with fewer than five measurements, and achieves the same compensation accuracy compared to the state-of-the-art method when the number of measurements is greater. Moreover, our method eliminates the need for robot installation angle.
27 December 2024 in Robotics and Autonomous Systems
The Chinese Fusion Engineering Testing Reactor (CFETR) divertor development is ongoing by further optimizing a water-cooled engineering design scheme and implementing the research and development of small-and medium-sized test mock-ups and prototype fabrication. To increase the tritium breeding ratio (TBR), the design scheme adopts a hybrid divertor–blanket integration concept where a breeding blanket is placed underneath targets instead of a cassette. The novel front-face remote handling (RH) targets are designed aiming to explore whether the targets could be maintained from the plasma side. Three unique independent RH design schemes are developed separately for the inner, dome, and outer targets. Hypervaportron flat-tile units are optimized in the high heat flux (HHF) area with an engineering requirement of 20 MW/m $^{2}$ steady-state heat load. All the targets have good RH compatibility with RH tools in the maintenance procedure. Preliminary analysis with respect to pumping performance, hydraulics, heat removal ability, and structure meets the requirements. The research and development is based on advanced fusion reactor materials and realizable materials’ connection technology. The advanced materials of potassium-doped tungsten (KW), oxide dispersion-strengthened copper (ODS-Cu) alloy, and reduced activation ferritic/martensitic (RAFM) steel are used as armor, heat sink, and structural materials, respectively. One of the realizable material connection routes is that RAFM steel is explosively welded with ODS-Cu and then the KW/Cu flat tiles are brazed with ODS-Cu. The small-sized mock-up successfully endured 1000 cycles with 20 MW/m $^{2}$ steady-state heat load. The maximum temperature of the KW surface was 882 $^{\circ}$ C, much lower than the supposed recrystallization temperature. The ultrasonic testing (UT) showed no defects exceeding $\Phi $ 2 mm equivalent before/after the testing. The medium-sized mock-up showed that the UT results meet the requirements and the profile error of the plasma-facing surface is less than 1 mm. All this work will be beneficial for the final engineering design of the CFETR divertor.