In the rapid growth of perovskite solar cells, there are still specific issues regarding the extensive absorption of incident photons. Double-layered methyl ammonium (MA)-free perovskite solar cells (PSC) have been proposed to sort out these issues. The material absorber in solar cells based on MA-free and cesium-based perovskite, i.e., Cs2BiAgI6, is a critical parameter because of its non-volatile nature as well as its band gap of 1.6 eV being helpful in a broader visible absorption spectrum than the conventional CH3NH3PbI3 material. Moreover, the quantum efficiency (QE) and power conversion efficiency (PCE) in a configuration with MXene + TiO2 as the electron transport layer (ETL) in the PSC can make improvements over a more extensive range. The results of the current modeling of numerical simulations are used to investigate the exclusive optoelectrical outputs of the PSC. Furthermore, we use a novel approach of an ETL of MXene + TiO2 in a PSC, which will lower the manufacturing cost and defectiveness. The present work compares different ETLs to attain the best PCE using Cs2BiAgI6 as a perovskite absorber layer (PAL). The results are exciting as the highest open circuit voltage (VOC) of 1.48 V, high short current density (JSC) of 22.8 mA cm−2, with a high fill factor (FF) of nearly 84.6% in the double-layered PSC offer a high power conversion efficiency (PCE) of more than 28%. The designed outputs will be efficient for the convenient fabrication of the PSC.
1 October 2023 in Journal of Physics and Chemistry of Solids
One of the major limitations causing deadlock in solar cells with higher sulfur content in the photovoltaic absorber material is the unintended formation of an uncontrollable MoS2 layer between the absorber material and Mo back contact, which can affect negatively the efficiency of solar cells. Researchers reported that it is very difficult to control the MoS2 properties such as the conductivity type, thickness, band gap, and carrier concentration in experiments. Considering these challenges, an initial step involved a thorough examination utilizing the one-dimensional solar cell capacitance simulator (SCAPS-1D) to assess the impact of n-MoS2 interlayer thickness and donor concentration on the performance of CMTS solar cells. Our investigation revealed the formation of a “cliff-like CBO” at the CMTS/n-MoS2 interface, facilitating the transport of electrons from the p-CMTS absorber to the Mo back contact, resulting in a significantly higher recombination rate. Subsequently, herein a novel approach is proposed, using Cu2O as a back surface field (BSF) layer due to its low cost, intrinsic p-type properties, and non-toxic nature. Simulation results of a novel heterostructure (Mo/Cu2O/CMTS/CdS/i-ZnO/AZO/Al) of the CMTS-based solar cell are discussed in terms of recombination rate and conduction band alignment at the absorber/BSF interface. A desired “spike-like CBO” is formed between CMTS/Cu2O, which hinders the transport of electrons to the back contact. By optimizing the physical parameters such as thickness and the doping density of the Cu2O layer, an efficiency η of 21.78% is achieved, with an open circuit voltage (Voc) of 1.26 V, short-circuit current density (Jsc) of 24.45 mA/cm², and fill factor (FF) of 70.85%. Our simulation results offer a promising research direction to further develop highly efficient and low-cost CMTS solar cells.