A new grain growth model was developed by introducing the ultimate grain size to the traditional model. The grain growth behavior and its ultimate size under the Zenner pinning force are also discussed. This model was applied to the nickel-based superalloy and integrated into an FEM code. The grain evolution of a forged third-generation powder superalloy heat treated at different temperatures and holding times was studied. A gradient heat treatment setup was designed and implemented for a full-size turbine disc based on the model prediction to meet the accurate dual-microstructure requirements of an advanced aero-engine turbine disc design. The predicted temperature was validated by thermal couple measurements. The relative error between the prediction and the measurements is less than 2%. The metallographic examination of the whole turbine disk through sectioning showed that the grain size was ASTM 7-8 at the rim area and ASTM 11-12 at the bore region, which agrees well with the prediction. The predicted values of the three measurement areas are ASTM 12.1, ASTM 9.1, and ASTM 7.1, respectively, with a maximum error of 5% compared to the measured values. The proposed model was validated and successfully applied to help manufacture a dual-microstructure aero-engine turbine disc.
Regulating the microstructure of powder metallurgy (P/M) nickel-based superalloys to achieve superior mechanical properties through heat treatment is a prevalent method in turbine disk design. However, in the case of dual-performance turbine disks, the complexity and non-uniformity of the heat treatment process present substantial challenges. The prediction of yield strength is typically derived from the analysis of microstructures under various heat treatment regimes. This method is time-consuming, expensive, and the accuracy often depends on the precision of microstructural characterization. This study successfully employed a coupled method of Artificial Neural Network (ANN) and finite element analysis (FEA) to reveal the relationship between the heat treatment process and yield strength. The coupled method accurately predicted the location specified and temperature-dependent yield strength based on the heat treatment parameters such as holding temperatures and cooling rates. The root mean square error (RMSE) and mean absolute percentage deviation (MAPD) for the training set are 50.37 and 3.77, respectively, while, for the testing set, they are 50.13 and 3.71, respectively. Furthermore, an integrated model of FEA and ANN is established using a Abaqus user subroutine. The integrated model can predict the yield strength based on temperature calculation results and automatically update material properties of the FEA model during the loading process simulation. This allows for an accurate calculation of the stress–strain state of the turbine disk during actual working conditions, aiding in locating areas of stress concentration, plastic deformation, and other critical regions, and provides a novel reliable reference for the rapid design of the turbine disk.
Heat treatment, particularly solution heat treatment, is a critical process in the preparation of powder metallurgy superalloys, where the cooling process significantly impacts the microstructure. This study, based on thermodynamic and kinetic databases as well as the precipitation mechanism of strengthening phases, delves into the influence of cooling process, especially the cooling path, on the material’s microstructure. The results indicate that under slow cooling rates, the precipitated phases are more likely to exhibit a multimodal size distribution, while under rapid cooling rates, a unimodal distribution may form. The average cooling rate does not consistently accurately reflect the growth of the precipitated phases; even with the same average cooling rate, different cooling paths can lead to significant differences in the size of the precipitates. To accurately predict the size of the precipitates, it is necessary to consider the specific cooling process. Constant cooling rate experiments designed for the study and the dissection testing of full-size turbine discs produced in manufacturing validated the calculated results of the precipitates. Therefore, optimizing cooling through simulation calculations can effectively and accurately control the precipitates, thereby obtaining a microstructure that can meet performance requirements.