We have proposed a structural design for a single photon avalanche diode with a low breakdown voltage. This diode is fabricated using Taiwan Semiconductor Manufacturing Company (TSMC) 0.18 μm HV CMOS technology, and it can maintain a high operating excess voltage in an n-on-p design without requiring any additional customized well layers. The n-on-p type device is particularly advantageous for a 3D-stacked backside illuminated structure and offers excellent photon detection capabilities at longer wavelengths. By incorporating a high doping concentration PDD well layer, we can significantly increase the excess bias, resulting in enhanced photon detection probability in the near-infrared wavelength range, all while maintaining a lower voltage due to a reduction in breakdown voltage. This design also leads to power consumption savings. As a result, our designed device is well-suited for consumer applications such as 3D image rendering and LiDAR technology.
27 October 2023 in IEEE Transactions on Instrumentation and Measurement
The sensitivity of a silicon photomultiplier (SiPM) can be enhanced to the level of single photon detection by combining the outputs of multiple single photon avalanche diode (SPAD) pixels. In this study, we utilized a pixel array consisting of 64x128 SPAD pixels that can switch and combine the outputs of multiple pixels to achieve a high detection dynamic range based on the photon power of the radiometric measurement scenario. Additionally, we accounted for the uncertainty associated with the dark count rate (DCR) in the theory calculation, which enabled us to extend the lowest detectable radiometric temperature to 225°C, matching the theoretical calculation. Moreover, we successfully maintained the capability of detecting the highest temperature at 1050°C, achieving a noise equivalent temperature difference (NETD) value below 1°C. Based on optical system modifications and calculation correction methods, our measurement results support that the SPAD image array is a much better radiometric sensor compared to CMOS sensors and CCD cameras.
We propose and verify on-chip temperature-sensing using single-photon avalanche diodes (SPAD) in CMOS process. The dark count rate of SPAD is sensitive to device temperature and of use for temperature monitoring. The best measured noise-equivalent temperature-difference is less than 0.17 °C over the range of 10 - 60 °C. A 32x32 SPAD array with an on-chip heat source has been deployed to demonstrate its capability of 2-D temperature mapping. The good consistence between the measured temperature distributions and the simulated ones has been observed.
Image sensors such as single-photon avalanched diode (SPAD) arrays typically adopt in-pixel quenching and readout circuits, and the under-illumination first-stage readout circuits often employs high-threshold input/output (I/O) or thick-oxide metal-oxide-semiconductor field-effect transistors (MOSFETs). We have observed reliability issues with high-threshold n-channel MOSFETs when they are exposed to strong visible light. The specific stress conditions have been applied to observe the drain current (Id) variations as a function of gate voltage. The experimental results indicate that photo-induced hot electrons generate interface trap states, leading to Id degradation including increased off-state current (Ioff) and decreased on-state current (Ion). The increased Ioff further activates parasitic bipolar junction transistors (BJT). This reliability issue can be avoided by forming an inversion layer in the channel under appropriate bias conditions or by reducing the incident photon energy.