In this in vitro study, we assessed the color stability of an A-2186 room-temperature-vulcanizing (RTV) silicone elastomer by incorporating silver nanoparticles during accelerated artificial aging. Using five intrinsic silicone pigment types, including no pigment (colorless), red, blue, mocha, and a combination of the three, we created 160 disk-shaped specimens. These were evenly distributed across 20 experimental groups, each containing 8 samples (n = 8). The specimens underwent aging for 250 and 500 h in an artificial aging chamber. A colorimeter was used to measure the values of L*a*b* according to the Commission Internationale de L’Éclairage (CIE) standards. The 50:50% perceptibility threshold (∆E* = 1.1) and acceptability threshold (∆E* = 3.0) were used in the interpretation of the recorded color differences. At the 0.05 level of significance, the one-way analysis of variance (ANOVA) and Tukey post hoc test were used in the statistical analysis. Fourier-transform infrared spectroscopy with attenuated total reflectance (FTIR-ATR) showed that 0.2% AgNPs after 500 h of aging protected the silicone elastomer matrix and all characteristic bonds of the silicone elastomer. In contrast, silicone without AgNPs showed the distortion of all bonds after 500 h. Chromatic alterations (∆E* > 0) were observed in all specimen groups, surpassing the perceptible threshold (1.1 units), except for mocha, with 0.2% AgNPs after 250 h of aging, which remained below the perceptible threshold (∆E* = 0.97). All groups demonstrated ∆E* values below the acceptable threshold, except for the red color, which exhibited a highly significant color change (p = 0.000). This study determined that all specimens, including colorless silicone, underwent color changes (∆E* > 0), with red displaying a notably significant chromatic alteration. Additionally, AgNPs demonstrated substantial protection of the silicone and reduced the color change across all groups and colors, with enhanced efficacy corresponding to higher AgNP concentrations (0.2% AgNPs > 0.15% AgNPs > 0.1% AgNPs).
This study aimed to investigate the effect of time and different disinfecting agents on nanocomposite filler composed of natural clay nanoparticles (modified and non-modified) added to maxillofacial silicone elastomers and readymade pigment additives. A total of 360 disk-shaped samples were divided into nine pigment-based groups, each with four subgroups (n = 10) exposed to different disinfectants: distilled water, 1% sodium hypochlorite (NaOCl), 2% chlorhexidine (CHX), and effervescent tablets. Color changes (ΔE) were measured before and after disinfection using a colorimeter. The ΔE values were assessed against perceptibility (ΔE = 1.1) and acceptability (ΔE = 3) thresholds. Nanoclay additives were also characterized using FTIR, XRD and EDX. Statistical analysis, including ANOVA and post hoc HSD tests, revealed that while all samples exhibited some color change, most remained below the acceptability threshold. Colorless silicone showed minimal, non-significant change according to perceptibility threshold (ΔE = 1.1). Blue pigments displayed significant change only with effervescent tablets. Red and mixed pigments showed perceptible changes with NaOCl, CHX, and effervescent tablets. However, nanoclay-containing specimens showed no significant perceptible alterations. Overall, despite minor perceptible changes in some pigments, all disinfecting agents tested resulted in color differences below the acceptability threshold, indicating their safe use for disinfecting maxillofacial silicone materials without compromising esthetics. Nevertheless, nanoclays are more reliable agents for the pigmentation of maxillofacial silicone as they show non-significant chromatic alteration.