The restoration of class II cavities is predominantly carried out with composite materials. Due to the high failure rate in restoring this type of cavity, composite materials with much-improved properties and new application techniques have been promoted. The study aimed to analyze the mechanical behavior of several topical composite materials (nanocomposites, nanohybrids and ormocer) using different application techniques. In a lower second molar, a class II occlusal cavity was prepared. As filling materials, we used the following combinations: Admira Fusion and Admira Fusion Flow, Grandio and Grandio Flow, Filtek Supreme XT and Filtek Supreme Flow. These were applied using a snow plow, injection molded and Bichacho techniques. Three-dimensional scanning of the molar with the prepared cavity was performed, and then scanning of each layer of added composite material was performed, obtaining three-dimensional models. The virtual molar models were analyzed with software specific to the finite element analysis method, where their physical-mechanical properties were entered and assigned to the components of the virtual molar. Simulations at high forces specific to bruxism were then carried out and analyzed, and compared. The values of displacements and strain, for all six analyzed situations, are relatively small (range from 5.25 × 10⁻⁶–3.21 × 10⁻⁵ for displacement, 6.22 × 10⁻³–4.34 × 10⁻³ for strain), which validates all three methods and the materials used. As far as the stress values are concerned, they are similar for all methods (250–300 MPa), except for the snow plow and injection-molded techniques using Grandio and Grandio Flow composites, where the maximum von Mises stress value was more than double (approximately 700 MPa). When using the combination of Grandio and Grandio Flow materials, the 1 mm thickness of the fluid composite layer was found to have a major influence on occlusal forces damping as opposed to 0.5 mm. Therefore, the Bichacho technique is indicated at the expense of the snow plow and injection-molded techniques. The composite materials used by us in this study are state-of-the-art, with clear indications for restoring cavities resulting from the treatment of carious lesions. However, their association and application technique in the case of Class II cavities is of clinical importance for resistance to masticatory forces.

Acromegaly-related sub/infertility, tidily related to suboptimal disease control (1/2 of cases), correlates with hyperprolactinemia (1/3 of patients), hypogonadotropic hypogonadism—mostly affecting the pituitary axis in hypopituitarism (10–80%), and negative effects of glucose profile (GP) anomalies (10–70%); thus, pregnancy is an exceptional event. Placental GH (Growth Hormone) increases from weeks 5–15 with a peak at week 37, stimulating liver IGF1 and inhibiting pituitary GH secreted by normal hypophysis, not by somatotropinoma. However, estrogens induce a GH resistance status, protecting the fetus form GH excess; thus a full-term, healthy pregnancy may be possible. This is a narrative review of acromegaly that approaches cardio-metabolic features (CMFs), somatotropinoma expansion (STE), management adjustment (MNA) and maternal-fetal outcomes (MFOs) during pregnancy. Based on our method (original, in extenso, English—published articles on PubMed, between January 2012 and September 2022), we identified 24 original papers—13 studies (3 to 141 acromegalic pregnancies per study), and 11 single cases reports (a total of 344 pregnancies and an additional prior unpublished report). With respect to maternal acromegaly, pregnancies are spontaneous or due to therapy for infertility (clomiphene, gonadotropins or GnRH) and, lately, assisted reproduction techniques (ARTs); there are no consistent data on pregnancies with paternal acromegaly. CMFs are the most important complications (7.7–50%), especially concerning worsening of HBP (including pre/eclampsia) and GP anomalies, including gestational diabetes mellitus (DM); the best predictor is the level of disease control at conception (IGF1), and, probably, family history of 2DM, and body mass index. STE occurs rarely (a rate of 0 to 9%); some of it symptoms are headache and visual field anomalies; it is treated with somatostatin analogues (SSAs) or alternatively dopamine agonists (DAs); lately, second trimester selective hypophysectomy has been used less, since pharmaco-therapy (PT) has proven safe. MNA: PT that, theoretically, needs to be stopped before conception—continued if there was STE or an inoperable tumor (no clear period of exposure, preferably, only first trimester). Most data are on octreotide > lanreotide, followed by DAs and pegvisomant, and there are none on pasireotide. Further follow-up is required: a prompt postpartum re-assessment of the mother’s disease; we only have a few data confirming the safety of SSAs during lactation and long-term normal growth and developmental of the newborn (a maximum of 15 years). MFO seem similar between PT + ve and PT − ve, regardless of PT duration; the additional risk is actually due to CMF. One study showed a 2-year median between hypophysectomy and pregnancy. Conclusion: Close surveillance of disease burden is required, particularly, concerning CMF; a personalized approach is useful; the level of statistical evidence is expected to expand due to recent progress in MNA and ART.

We aim to review data on 3beta-hydroxysteroid dehydrogenase type II (3βHSD2) deficiency. We identified 30 studies within the last decade on PubMed: 1 longitudinal study (N = 14), 2 cross-sectional studies, 1 retrospective study (N = 16), and 26 case reports (total: 98 individuals). Regarding geographic area: Algeria (N = 14), Turkey (N = 31), China (2 case reports), Morocco (2 sisters), Anatolia (6 cases), and Italy (N = 1). Patients’ age varied from first days of life to puberty; the oldest was of 34 y. Majority forms displayed were salt-wasting (SW); some associated disorders of sexual development (DSD) were attendant also—mostly 46,XY males and mild virilisation in some 46,XX females. SW pushed forward an early diagnosis due to severity of SW crisis. The clinical spectrum goes to: premature puberty (80%); 9 with testicular adrenal rest tumours (TARTs); one female with ovarian adrenal rest tumours (OARTs), and some cases with adrenal hyperplasia; cardio-metabolic complications, including iatrogenic Cushing’ syndrome. More incidental (unusual) associations include: 1 subject with Barter syndrome, 1 Addison’s disease, 2 subjects of Klinefelter syndrome (47,XXY/46,XX, respective 47,XXY). Neonatal screening for 21OHD was the scenario of detection in some cases; 17OHP might be elevated due to peripheral production (pitfall for misdiagnosis of 21OHD). An ACTH stimulation test was used in 2 studies. Liquid chromatography tandem–mass spectrometry unequivocally sustains the diagnostic by expressing high baseline 17OH-pregnenolone to cortisol ratio as well as 11-oxyandrogen levels. HSD3B2 gene sequencing was provided in 26 articles; around 20 mutations were described as “novel pathogenic mutation” (frameshift, missense or nonsense); many subjects had a consanguineous background. The current COVID-19 pandemic showed that CAH-associated chronic adrenal insufficiency is at higher risk. Non-adherence to hormonal replacement contributed to TARTs growth, thus making them surgery candidates. To our knowledge, this is the largest study on published cases strictly concerning 3βHSD2 deficiency according to our methodology. Adequate case management underlines the recent shift from evidence-based medicine to individualized (patient-oriented) medicine, this approach being particularly applicable in this exceptional and challenging disorder.

The purpose of this study was to show the improved outcomes of restoring endodontically treated teeth with fiberglass posts compared to restorations using metal posts. In our study, we used the Finite Element Method (FEM), which is based on the principle that a physical model that supports a given load distributes the stress throughout its volume. We sought to assess what stress results in a tooth when it is restored using a fiberglass post compared to restoration using a metal post. The finite element analysis showed that a system consisting of a tooth with a fiberglass post is more stable in terms of the maximum stress than a system consisting of a tooth with a metal post. The maximum displacements and deformations were obtained in the case of a canine restored with a fiberglass post, which showed that this system had a high elasticity, therefore, higher strength than a canine restored with a metal post, which had high rigidity.