Carbon nanotubes (CNTs) are considered as one of the ideal modifiers of cement materials, since CNTs can improve the mechanical properties of cement paste effectively. However, the interfacial interaction between CNTs and the cement matrix is weak. Moreover, it is difficult to disperse CNTs within cement paste. To overcome these shortages, in this study, CNTs were firstly dispersed into a styrene-acrylic emulsion (SAE). Then the homo-dispersion CNT/SAE emulsion was incorporated into cement paste. The effect of the CNT/SAE hybrid-system on the mechanical properties and microstructure of cement paste was studied. For purposes of comparison, the properties of cement paste mono incorporating CNTs or SAE are also investigated. The results show that CNT/SAE network films could be observed in cement paste by using a field emission scanning electron microscope (FESEM). These network films could bridge the cracks and refine the pores of a cement matrix. Infrared analysis and Raman spectroscopy show that the CNT/SAE hybrid modifier has stronger interfacial adhesion and better load transfer ability over the mono adding of CNTs and SAE emulsion. As a result, the hybrid addition of CNT/SAE significantly improved the flexural strength of cement paste. Especially, the addition of 0.1% CNTs and 15% SAE by mass of cement improved the 28-day flexural strength of cement paste by 21% and 25% as compared to the mono addition of CNTs or SAE, respectively.
Road traffic transportation has flourished in the process of urbanization due to its advantages, but concurrently it generates harmful environmental vibrations. This vibration issue becomes particularly crucial in production workshops housing precision instruments. However, limited research has been undertaken on this matter. This study aimed to investigate the influence of road traffic-induced vibration on micro-vibrations within a workshop housing precision instruments. A field test was conducted to assess the vibration levels originating from both machinery operation and vehicular traffic. The results indicated that ground-borne vibrations caused by road vehicles decrease with increasing propagation distance, peaking around 10 Hz. Machinery operation vibrations were primarily concentrated above 20 Hz, while vehicular traffic vibrations were more prominent below 20 Hz. Notably, the passage of heavy trucks significantly impacted both ground and workshop vibrations, with vertical vibrations being particularly significant. Within the workshop, the second floor experienced higher vibrations above 20 Hz due to the presence of installed instruments. Importantly, the micro-vibration levels on both floors exceeded the VC-C limit (12.5 µm/s), highlighting the need to account for road traffic and machinery vibrations in workshop design. These data can be utilized to validate numerical models for predicting road traffic-induced vibrations, aiding in vibration assessment during road planning and design.
Road traffic transportation has flourished in the process of urbanization by its advantages, but it also produces harmful environmental vibrations. The vibration problem is especially significant for production workshops with precision instruments. A field measurement was conducted to analyze the source characteristics and propagation laws of traffic-induced vibrations. Off the northern side of an urban highway lies a microelectronics workshop. When a large truck passes by, both the vibration responses on the ground and in the workshop considerably increase. Greater vibration is produced in the vertical direction than in the X and Y axes. The predominant frequency band of the vibration response caused by road traffic vehicles is lower than 20 Hz. The vertical vibration responses of the first and second floors in the workshop greatly exceed the VC-C limit because of the high daily traffic flow. Attribute to the excitation of the operation of the manufacturing equipment on the second floor, the vertical vibration level of the second floor is essentially higher than that of the first floor. Therefore, it is impossible to disregard the micro-vibration in the workplace produced by the manufacturing machinery as well as the ex-citement of the road traffic. The measured data can be used to test potential numerical models for forecasting vibrations caused by traffic on roads as well as to guide vibration assessment work throughout the planning and design stages of roads.