Two acid thickeners, ADMC and ADOM, were prepared by aqueous solution polymerization using acrylamide (AM) and methacryloyloxyethyl trimethyl ammonium chloride (DMC) as raw materials, with or without the introduction of octadecyl polyoxyethylene ether methacrylate (OEMA). It was characterized by FTIR, 1H NMR, and the fluorescence spectra of pyrene. The double-layer thickening mechanism of ADOM was proved by comparing the thickening and rheological properties of ADMC and ADOM tested by a six-speed rotary viscometer and a HAKKE MARSIV rheometer during the acidification process. The results showed that the synthetic product was the target product; the first stage of the self-thickening ADOM fresh acid solution during high-temperature acidification was mainly affected by Ca2+ concentration, and the second stage of self-thickening was mainly affected by temperature. The residual viscosity of the 0.8 wt% ADOM residual acid solution was 250, 201.5, and 61.3 mPa·s, respectively, after shearing at 90, 120, and 150 °C for 60 min at a shear rate of 170 s−1. The thickening acid ADOM with a hydrophobic association structure has good temperature resistance and shear resistance, which can be used for high-temperature deep-well acid fracturing. In addition, no metal crosslinking agent was introduced in the system to avoid damage to its formation, and ADOM exhibited good resistance to Ca2+, which could provide ideas for the reinjection of the acidizing flowback fluid. It also has certain advantages for environmental protection.
Urethane surfactants (REQ) were synthesized with octadecanol ethoxylate (AEO) and isocyanate methacrylate (IEM). Subsequently, reactive-carbamate-surfactant-modified nanomicrospheres (PER) were prepared via two-phase aqueous dispersion polymerization using acrylamide (AM), 2-acrylamido-2-methylpropanesulfonic acid (AMPS) and ethylene glycol dimethacrylate (EGDMA). The microstructures and properties of the nanomicrospheres were characterized and examined via infrared spectroscopy, nano-laser particle size analysis, scanning electron microscopy, and in-house simulated exfoliation experiments. The results showed that the synthesized PER nanomicrospheres had a uniform particle size distribution, with an average size of 336 nm. The thermal decomposition temperature of the nanomicrospheres was 278 °C, and the nanomicrospheres had good thermal stability. At the same time, the nanomicrospheres maintained good swelling properties at mineralization < 10,000 mg/L and temperature < 90 °C. Under the condition of certain permeability, the blocking rate and drag coefficient gradually increased with increasing polymer microsphere concentration. Furthermore, at certain polymer microsphere concentrations, the blocking rate and drag coefficient gradually decreased with increasing core permeability. The experimental results indicate that nanomicrospheres used in the artificial core simulation drive have a better ability to drive oil recovery. Compared with AM microspheres (without REQ modification), nanomicrospheres exert a more considerable effect on recovery improvement. Compared with the water drive stage, the final recovery rate after the drive increases by 23.53%. This improvement is attributed to the unique structural design of the nanorods, which can form a thin film at the oil–water–rock interface and promote oil emulsification and stripping. In conclusion, PER nanomicrospheres can effectively control the fluid dynamics within the reservoir, reduce the loss of oil and gas resources, and improve the economic benefits of oil and gas fields, giving them a good application prospect.
The structures and properties of hydrophobic association polymers can be controlled using micelles. In this work, we synthesize a reactive hydrophobic surfactant monomer, KS-3, from oleic acid, N,N-dimethylpropylenediamine, and allyl chloride. A strong synergistic effect between KS-3 and cocamidopropyl betaine in aqueous solution enhances the hydrophilic dispersibility of KS-3, thereby transforming spherical micelles into cylindrical micelles. KS-3 was grafted onto a polyacrylamide chain via aqueous free-radical polymerization to obtain RES, a hydrophobic association polymer. Structural analysis revealed that the RES polymers assembled in wormlike micelles were more tightly arranged than those assembled in spherical micelles, resulting in a compact network structure in water, smooth surface, and high thermal stability. Rheological tests revealed that the synthesized polymers with wormlike and spherical micelles exhibited shear-thinning properties along with different structural strengths and viscoelasticities. Therefore, controlling the micellar state can effectively regulate the polymer properties. The polymers obtained through wormlike micelle polymerization have potential applications in fields with high demands, such as drug release, water purification, and oilfield development.