Guangliang Jia

Guangliang Jia

Auto-generated profile, based on publicly available information

Guangliang Jia

Sinopec Huabei Petroleum Engineering Co., Ltd., Zhengzhou 450006, China

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 March 2024 in Polymers
Verified
Journal Article
Open access
PDF file
PLPeng Li
Peng Li
LWLei WANG
Lei WANG
XLXiaojuan Lai
Xiaojuan Lai
JGJinhao Gao
Jinhao Gao
ZDZhiqiang Dang
Zhiqiang Dang
GJGuangliang Jia
Guangliang Jia
Two acid thickeners, ADMC and ADOM, were prepared by aqueous solution polymerization using acrylamide (AM) and methacryloyloxyethyl trimethyl ammonium chloride (DMC) as raw materials, with or without the introduction of octadecyl polyoxyethylene ether methacrylate (OEMA). It was characterized by FTIR, 1H NMR, and the fluorescence spectra of pyrene. The double-layer thickening mechanism of ADOM was proved by comparing the thickening and rheological properties of ADMC and ADOM tested by a six-speed rotary viscometer and a HAKKE MARSIV rheometer during the acidification process. The results showed that the synthetic product was the target product; the first stage of the self-thickening ADOM fresh acid solution during high-temperature acidification was mainly affected by Ca2+ concentration, and the second stage of self-thickening was mainly affected by temperature. The residual viscosity of the 0.8 wt% ADOM residual acid solution was 250, 201.5, and 61.3 mPa·s, respectively, after shearing at 90, 120, and 150 °C for 60 min at a shear rate of 170 s−1. The thickening acid ADOM with a hydrophobic association structure has good temperature resistance and shear resistance, which can be used for high-temperature deep-well acid fracturing. In addition, no metal crosslinking agent was introduced in the system to avoid damage to its formation, and ADOM exhibited good resistance to Ca2+, which could provide ideas for the reinjection of the acidizing flowback fluid. It also has certain advantages for environmental protection.

1 July 2018 in Energies
Verified
Journal Article
Open access
PDF file
KAKun Ai
Kun Ai
LDLongchen Duan
Longchen Duan
HGHui Gao
Hui Gao
GJGuangliang Jia
Guangliang Jia
Hydraulic fracturing optimization is very important for low permeability reservoir stimulation and development. This paper couples the fracturing treatment optimization with fracture geometry optimization in order to maximize the dimensionless productivity index. The optimal fracture dimensions and optimal dimensionless fracture conductivity, given a certain mass or volume of proppant, can be determined by Unified Fracture Design (UFD) method. When solving the optimal propped fracture length and width, the volume and permeability of the propped fracture should be determined first. However, they vary according to the proppant concentration in the fracture and cannot be obtained in advance. This paper proposes an iterative method to obtain the volume and permeability of propped fractures according to a desired proppant concentration. By introducing the desired proppant concentration, this paper proposes a rapid semi-analytical fracture propagation model, which can optimize fracture treatment parameters such as pad fluid volume, injection rate, fluid rheological parameters, and proppant pumping schedule. This is achieved via an interval search method so as to satisfy the optimal fracture conductivity and dimensions. Case study validation is conducted to demonstrate that this method can obtain optimal solutions under various constraints in order to meet different treatment conditions.